Put your positive of the multimeter on center pin of the 510 connection then touch the negative anywhere else on the atty (or the negative post) and check the reading. It should be pretty close to that 2.1
take switch off, take batt out. put atomizer in. now read resistance by putting positive probe on brass piece in bottom where batt + would make contact, and negative probe on body of atomizer. should read 2-2.1 ohm. it does? if so it should be ok. it doesn't and reads 0 or much less then 2.1ohm? it is either a short in connection or in MS.
Now take atomizer out. put positive probe in same spot. negative probe to either brass threading... or to edge of 510 connection on MS (ground/return). it should read open. if it does read open, 510 connection is shorting to ground of atomizer, and it is connection. if it reads a short, the MS is bad and will need disassembly to isolate or return to fix.
Mine is in NY. Just hanging out. Hopefully it will leave there soon.
"We like to play with things a while, before annihilation."
Ordered late yesterday and shipped today!! Hooray!
Sent from my iPad using Tapatalk
Ordered late yesterday and shipped today!! Hooray!
Sent from my iPad using Tapatalk
Wow! Lucky you! They must have had a few extras that they released for sale to ship with the last batch (mine). I ordered Jan 19 and it just shipped yesterday.
He ordered from the US supplier when they got stock yesterday.
You are so right!! Wanted one, then on the fence, then ordered!! Woohoo!
Sent from my iPad using Tapatalk