Need HELP figuring out ohms for braids

[Thumpszilla]

Ok I have been learning to do braided coils and I have the braiding part down. The problem I am having is figuring out how many wraps to hit my target ohms rating. The last one I did was a vertebraid 6 strands of 28g 316l stainless steel and it took 8 wraps on a dual coil to hit .106. This morning I did a fishtail braid which is 10 strands of 28g 316l stainless. How many wraps to get to at least .15 dual coil going in a goon rda?

 

[Izan]

Hi,
Use a DMM to measure the resistance of the un coiled wire
Attach a length of un coiled wire to your rda posts and measure.

Wraps don't much come into play. The length of the wire will determine final resistance.

cheers
I

 

[Thumpszilla]

Well with this new braid there is 40ft of wire in an 18 inch piece of braid.

Sent from my Z981 using Tapatalk

 

[Thumpszilla]

Single coil 5 wraps around a 3mm rod came to .09. However the wire is so wide 6 wraps wouldn't have fit in my goon RDA so no alien for this build it will have to sit on my ipv3.

Sent from my Z981 using Tapatalk