Need some help with 510 mode

Status
Not open for further replies.

jcwest

Super Member
ECF Veteran
Verified Member
Aug 16, 2012
448
507
43
Pontotoc MS
I put it together best i could from imeos video using 510 mode..

Put the top thing in the mouth piece with the o-ring

Put the o-ring on the black plastic thing at the base of it

screwed the brass post through the middle of the plastic thing

screwed the bottom plastic and post assembly into the housing

screwed the housing down to the base

scewed an atomizer to the housing

silver grounding nut on the housing

mouth piece on the housing

big mode tank on the unit..

top cap on

top o-ring on

top nut on

ALL thE JUCE RAN OUT THE BOTTOM..

Did i miss an o-ring? tere is one REALLY tiny o-ring in the expansion kit i cant find a use for as its WAY to tiny to go on the bottom post so where did i go wrong?
 

yankeebobo

Vaping Master
ECF Veteran
Verified Member
Jun 23, 2012
7,046
21,034
Western MA
3 x 1.78 Under center pin (all modes exept UFS mode)

is that the REALLY tiny one? does it go on the bottom of the center pin? if so i cant imagine how it fits..
It sounds like you missed that tiny oring on the bottom of the center pin - the same, it sounds like, you suspect. The pin goes through the oring below the nut that holds the pos wire. Then all that slides into the 510 base.
I'd lube it up a tad, and it may appear to stretch in order to go on, but that's where the leak is likely from.
 

imeothanasis

Unregistered Supplier
ECF Veteran
Feb 13, 2009
47,882
34,510
Athens, Hellas
gg-goldengreek.com
we used to put 3x1,78 o-ring around the center pin jc but we replace it with 1,78x1,78. In 510 mode the 3x1,78 is still ok.

prossedure:

screw the plastic inside to the thing that is almost like Ody's rebuildable part, from the surface that doesnt have the 4 vertical cuts
screw the center pin inside plastic
put o-ring around the center pin and screw the "rebuildable" part on base
screw atomizer
put an o-ring on the fat ring that goes inside the 510 mouthpiece and screw this fat ring inside 510 mouthpiece
put the mouthpiece around the atomizer, push it a little so atomizer will go inside mouthpiece and screw mouthpiece on the "rebuildable" part
fill with liquid, etc
 
Status
Not open for further replies.

Users who are viewing this thread