Needed: Tips for the ZFM mod

[jcleaver]

OK, I bought the ZFM mod kit. I figured I would at least get the first run I tried to be made by the pro.

Well, it arrived, and I filled the first cart up to just below the top of the straw. I replaced the top yellow foam piece and then attached the cart to my 510 atty, and started vaping. At first, I thought this is great. Then i noticed that the juice had leaked out all over the place. It may as well have not had any mod done. So far, I haven't tried again, but i know I am doing something wrong; but I can't figure out what.

Any help would be appreciated.

 

[Switched]

That mod was a large failure like many. I used this with great success http://www.e-cigarette-forum.com/forum/cartridge-mods/79418-highping-cart-mod-simple-gets.html

 

[Vaporblind]

zfm worked great for me made my own with H cut. Without this mod Vaping would be a PIA for me.

 

[jcleaver]

OK, I cut the straw ever so slightly, and the leaking problem appears to be gone. It is now working OK.