OBS Engine NANO RTA

Status
Not open for further replies.

Nailz

Vaping Master
ECF Veteran
Verified Member
  • Jun 6, 2013
    6,582
    30,401
    Wichita, KS
    So got mine today, now I do MTL vape, so to most this will be discarded :)

    Built my normal 1.5ohm 2.5mm clapton coil, mine does not have the offset post holes.
    Mb5SYFW.jpg


    Easy to build and wick, and like it is leak proof, but so far the flavor is not there, now due to no air slots to line up too, could be my wick placement, or just some time for the coil to break in, but right now the EXO rta is a lot better for flavor.

    Will say it is one of the best looking tanks, just no wow in flavor department, but will stick with it because it does look so good, hopefully figure out how to get better flavor, maybe try a 2mm coil as suggested.

    LqkxqPA.jpg
     

    janne303

    Super Member
    ECF Veteran
    Oct 6, 2014
    459
    541
    Sweden
    So got mine today, now I do MTL vape, so to most this will be discarded :)

    Built my normal 1.5ohm 2.5mm clapton coil, mine does not have the offset post holes.
    Mb5SYFW.jpg


    Easy to build and wick, and like it is leak proof, but so far the flavor is not there, now due to no air slots to line up too, could be my wick placement, or just some time for the coil to break in, but right now the EXO RTA is a lot better for flavor.

    Will say it is one of the best looking tanks, just no wow in flavor department, but will stick with it because it does look so good, hopefully figure out how to get better flavor, maybe try a 2mm coil as suggested.

    LqkxqPA.jpg
    Try higher position on the coil

    Skickat från min SM-G935F via Tapatalk
     

    Sed8op8

    Super Member
    ECF Veteran
    Jan 6, 2016
    721
    1,432
    35
    I find my 2 normal drinkers.

    I was using 3mm and up to 4mm coils until another member here suggested using a 2mm coil and I found the flavor even better. Try a 2mm coil and if yours has the off-set holes that hold the coil, keep it in the middle of the holes and see how it works. Also make sure you wind the coil counter clockwise to keep the leads short.
    Im a bit confused here your saying your getting Noticably better flavor with smaller I'd coils ?.... This is strange but if it works hell I'll give it a test drive
     

    Heartsdelight

    Vaping Master
    ECF Veteran
    Nov 10, 2015
    5,777
    19,659
    So got mine today, now I do MTL vape, so to most this will be discarded :)

    Built my normal 1.5ohm 2.5mm clapton coil, mine does not have the offset post holes.
    Mb5SYFW.jpg


    Easy to build and wick, and like it is leak proof, but so far the flavor is not there, now due to no air slots to line up too, could be my wick placement, or just some time for the coil to break in, but right now the EXO RTA is a lot better for flavor.

    Will say it is one of the best looking tanks, just no wow in flavor department, but will stick with it because it does look so good, hopefully figure out how to get better flavor, maybe try a 2mm coil as suggested.

    LqkxqPA.jpg
    I guess u just have to play with coil & wick mines great.
     

    ricks

    Vaping Master
    ECF Veteran
    Verified Member
    Jan 11, 2011
    7,245
    10,303
    61
    Moscow PA
    Im a bit confused here your saying your getting Noticably better flavor with smaller I'd coils ?.... This is strange but if it works hell I'll give it a test drive
    It is very strange... I still can't believe that I'm getting better flavor from smaller coils but it's true. Try it!
     

    Nailz

    Vaping Master
    ECF Veteran
    Verified Member
  • Jun 6, 2013
    6,582
    30,401
    Wichita, KS
    Can anyone recommend a dual battery 100 watt mod that the Engine Nano will fit nicely on? Right now I'm using an Eleaf Ipower 80 watt mod with a 5000mah internal battery.

    Look above where I posted picture of my setup, Therion is really nice dual battery mod, little pricey, but worth it though ;)
     

    dampfan

    Full Member
    Jan 3, 2016
    26
    43
    58
    Germany
    Easy to build and wick, and like it is leak proof, but so far the flavor is not there, now due to no air slots to line up too, could be my wick placement

    I agree. I tried several coil placements and sizes, but flavor never was that good. It was not bad in the sense of a bad flavor from a good e-juice, the flavor is kinda weak would describe it better, imho.
    It is really funny, i bought it because some german u tube reviewers told flavor was good.
    well, so far i did not get real good flavor out of it.
    it is easy to build and leakage free, but i miss the flavor i get from an Augvape Merlin, a Vapor Giant 4 or a Taifun GT III.
     
    • Like
    Reactions: TrollDragon

    ricks

    Vaping Master
    ECF Veteran
    Verified Member
    Jan 11, 2011
    7,245
    10,303
    61
    Moscow PA

    Herrick

    Super Member
    ECF Veteran
    Oct 21, 2016
    543
    1,010
    44
    Look above where I posted picture of my setup, Therion is really nice dual battery mod, little pricey, but worth it though ;)

    Thanks Nailz. I was looking into that one but the color scheme I like wasn't available. I'll keep looking though.
     

    Herrick

    Super Member
    ECF Veteran
    Oct 21, 2016
    543
    1,010
    44
    Last edited:

    Nailz

    Vaping Master
    ECF Veteran
    Verified Member
  • Jun 6, 2013
    6,582
    30,401
    Wichita, KS
    I agree. I tried several coil placements and sizes, but flavor never was that good. It was not bad in the sense of a bad flavor from a good e-juice, the flavor is kinda weak would describe it better, imho.
    It is really funny, i bought it because some german u tube reviewers told flavor was good.
    well, so far i did not get real good flavor out of it.
    it is easy to build and leakage free, but i miss the flavor i get from an Augvape Merlin, a Vapor Giant 4 or a Taifun GT III.

    Yes your right, flavor not bad, just muted right now, but will work with it for a while to see if can make it better ;)
     

    Heartsdelight

    Vaping Master
    ECF Veteran
    Nov 10, 2015
    5,777
    19,659
    Or on Vaporcube.com the Hohmtech 26650 Slice mod. It does 101 watt. Temperature Control really works well compared to all my other mods. Use code "slice" should cost about $30 after the discount. If you vape under 40 watts you can get an adaptor & use 1 18650 battery. There's a thread on ................. about them.
     
    Status
    Not open for further replies.

    Users who are viewing this thread