OFFICIAL AvidVaper.com HH.357 discussion thread

[Pega]

My review on a "FinnishSpecial" a Custom 100%VG, 901 style HH357 is on the Avid website, under custom reviews. I think it´s also post #1355 on this thread.

Many thanks for that, sadly I only use a REO mini, so 901 is a no go for me, dunno if it would work with a thread conversion thingie...

 

[Pega]

I'd be curious to know what the average life expectancy of HH 357 (LR and SR and HR) ... i assume most have the LR 1.5's ...
I tend to be superstitious about things like if it works good, don't try anything different, so i usually have a LR on hand...
I use vodka so far, but again, MWA doesn't do much of anything other than keep them wet, and he has the most life.

I would put mine (2.5ohms, personally I can't stand anything lower than that with 24mg Boba's, just kills the taste for me) at around 2 months with daily cleaning. I ordered 2 last time I bought some and I have been using them for 2 months (I only vape with HHs), still hit as hard as the first day.

 

[ukeman]

it's call an adapter; 510 to 901.... easy as can be; i'd recommend a "stealth" adapter (open end for b/f) ... some are cheapies and some are overpriced... the better vendors have stealth = lower profile. Any should work on the Reo. Many use a drip shield on the 901 because the air draw is a hole on the side and juice can leak out. I don't like what it does to the draw, but if the atty is too airy i use it.

Many thanks for that, sadly I only use a REO mini, so 901 is a no go for me, dunno if it would work with a thread conversion thingie...

 

[ukeman]

thank you.... food for thought.

I would put mine (2.5ohms, personally I can't stand anything lower than that with 24mg Boba's, just kills the taste for me) at around 2 months with daily cleaning. I ordered 2 last time I bought some and I have been using them for 2 months (I only vape with HHs), still hit as hard as the first day.

 

[hildicat]

Many thanks for that, sadly I only use a REO mini, so 901 is a no go for me, dunno if it would work with a thread conversion thingie...

I use the 901 HH on my Reo Grand and it is fantastic. Just one tip. I found the stealth adapter that Avid sells harder to use than a regular sized adapter. It may be that with the stealth adapter the atty sits too low for a drip shield to work properly. It almost seems like the bottom hole is being blocked by the lower o-ring of the drip shield.

On another note, my new V2 901 is performing quite well, but what I do notice is that it seemed to take much longer to break in correctly. Also, it seems much more prone to flooding. I feel that the older model would still produce good, but not optimal vapor when over fed. This new one just about quits if it has too much liquid, but its a fine line between perfect and flooded.
For reference I have a custom 901 (standard length) 1.8 ohm tuned for VG.

 

[Pega]

Any chance you could link an adapter that you have found works well with your grand for me?

I use the 901 HH on my Reo Grand and it is fantastic. Just one tip. I found the stealth adapter that Avid sells harder to use than a regular sized adapter. It may be that with the stealth adapter the atty sits too low for a drip shield to work properly. It almost seems like the bottom hole is being blocked by the lower o-ring of the drip shield.

On another note, my new V2 901 is performing quite well, but what I do notice is that it seemed to take much longer to break in correctly. Also, it seems much more prone to flooding. I feel that the older model would still produce good, but not optimal vapor when over fed. This new one just about quits if it has too much liquid, but its a fine line between perfect and flooded.
For reference I have a custom 901 (standard length) 1.8 ohm tuned for VG.

 

[hildicat]

Any chance you could link an adapter that you have found works well with your grand for me?

Unfortunately, most vendor's sites are block for me at work so I cannot give you a direct link right now. If you look at Empire Mods you should be able to find the 901-510 adapter. I have two of them and they perform flawlessly with any 901 I put on my 510 Reo.

www.empiremods.com

 

[ukeman]

I'm not good at links but just google ecig adapters stealth.. Ikenvape and Avid come to mind. If you google just ecig adapters you should get a ton of vendors... beware cheap stuff, but i think Madvapes is reputable i.e..

 

[wigglr]

Madvapes has great prices... I recommend them. Most vendors overcharge.

 

[Kalimero]

Regarding longevity, I was wondering what people who are using ultrasonic cleaners to clean these have experienced. I have turned to using vinegar (overnight) to soak the HHs, then I clean them by sealing the top with an 808 silicone mouthpiece and drawing fresh vinegar through them by inserting a syringe into the hole on the mouthpiece. After this, I rinse out ALL the vinegar with warm water and dry for about 5-10 minutes with a hair dryer blowing at the HHs. This gets the job done pretty well, but after 1 day, performance drops off again. Of course, atty killin' Boba's is probably contributing a lot to this.

I use an ultrasonic cleaner and I think it´s an essential part of my cleaning procedure. I also use vinegar but I combine it with baking soda.

 

[ukeman]

"...ah the humanity" If only Hanna would focus on a rebuildable HH357.... it would be big ... HH357

I use an ultrasonic cleaner and I think it´s an essential part of my cleaning procedure. I also use vinegar but I combine it with baking soda.

 

[eLguSo]

I am loving my HH. 357s...

The only thing which could make me happier would be ... Yesss, you guessed it: The Tank !!!

When will you launch this, H Bomb ?

 

[Pega]

I use an ultrasonic cleaner and I think it´s an essential part of my cleaning procedure. I also use vinegar but I combine it with baking soda.

Great idea, I'd forgotten about the baking sod+vinegar combination...off to try that now, got an HH to clean

 

[casualuser]

When you use baking soda + vinegar how long does it take to dry out before you can use it again?

 

[disfilam04]

whats the availability to buy one. I want to try one out! please pm me!

 

[Kalimero]

When you use baking soda + vinegar how long does it take to dry out before you can use it again?

I´ll just rinse it and it´s ready to go. No differ than after a PGA or Vodka soak. Just try to get most of the liquid out as you might get nice after burner effect...

 

[ukeman]

Is anyone else confused about the Custom order section offering only a choice of 100%VG or 100%PG... I usually order a blend, but now that i think about it, is the only legit reason to order a custom because you vape 100% of one or the other?

 

[Pega]

Just wondering do any of you HH users have extended experience with the genesis tank systems (rebuildable atomizer)? Just wondering how something like that, properly configured compares to the HH.

 

[Pega]

Is anyone else confused about the Custom order section offering only a choice of 100%VG or 100%PG... I usually order a blend, but now that i think about it, is the only legit reason to order a custom because you vape 100% of one or the other?

I think there are only custom 901s and custom color selections (not that I care for any of those) but I could be wrong...

 

[skullfreak]

I did a custom 357 should I have just ordered a reg one.
The juice blend through me off