Official DiscountVapers.com Thread

[Urge]

Eric wrote...

No one replied yet so I will just say that I did open one pack and did not notice anything, is this common for you or just a new thing on one pack? If they don't work for you, and are defective, remember I'll replace them.

The pack of 5 cartos that I got from you recently is the first time I've noticed a difference. It is not a problem, if anything it makes filling them faster. I don't know if there is a down side unless they hold less because of the filler absorption volume(does that make any sense?)
Also, in the same order as the cartos(I think) got a couple of drip tips and the rubbor O ring on one of them is just a scosh larger than all my other drip tips and it is a bear to put in or take out. Do you have any of those O rings or do you know what size the correct ones are? I can just run down to the hardware store and pick one up if I know what size or I suppose I could just take a carto and drip tip with me and try them.

Urge

 

[Spazmelda]

Are they the stainless drip tips? I had posted this earlier:

I found an o-ring that works for the stainless drip tips. The #6 Danco from Home Depot works pretty well. It could be a little tighter, but it slides in easily and doesn't fall out. The measurements on that one are 7/16" OD x 5/16" ID, 1/16.

If you search this thread for o-rings you can find a few posts where Eric and I were discussing the o-rings.

 

[gormly]

Are they the stainless drip tips? I had posted this earlier:

If you search this thread for o-rings you can find a few posts where Eric and I were discussing the o-rings.

Yea, take Spazmelda's advice not mine, I was wrong in my post about Orings

Personally I like the tight ones because I can hold it in my teeth when I am typing, like right now

 

[sonicdsl]

sonic, how long are the 2.5ml/3.5ml clear ones lasting for you? Can you change flavors easily?

Well I can halfway answer this I got them around 11/2 and immediately filled them w/two of my favorites, and they are still going strong (as far as I can tell, just as strong as two weeks ago!). I haven't changed flavors in them - haven't wanted to, so far. I'm almost out of one of them though, and will not be replenishing at this time as I have so many to go through

I'm assuming once it's depleted, I can rinse, blow, rinse, blow & let dry, then use a new liquid. From what I can see through the frosted case, I think it's basically a CE2 (or like it), and the ones I've had before were easy to clean and re-use. YMMV

 

[Urge]

Ok, I found the O ring info...

as far as Orings, HomeDepot
O-Ring #47 at Home Depot 11/32 x7/32 x 1/16. The second O-ring is metric 9mm x 5mm x 2mm.

or ZORO Tools - ZORO tools

I am not sure which is which yet, haven't had time to investigate.

I have never heard of Zoro tools are national?

I have the standard black drip tips. Are the stainless ones any different in size? I know that sounds crazy but I think I read something here about different sizes and Eric said he liked the tight ones(I'm not going there) so who knows.

Urge

 

[mohawkx]

What's happening to Chopper and his tanks? Do you expect to ever get some more in? Also, has he processed his registration with ECF?

 

[gormly]

What's happening to Chopper and his tanks? Do you expect to ever get some more in? Also, has he processed his registration with ECF?

Chopper gave me the go ahead to make them, but I am going to send him the supplies to make them instead, at least for now.
As far as his status, you'd have to ask him I do not know.

 

[gormly]

Yea!!

My First new exclusive product created and designed by me!
(well sort of, I told them what to make and how to fix it when it was broken LOL)

Go-go Jumbo battery
1. Takes 18650 Batteries (sorry not included, but in stock)
2. Runs at 3.6-3.8
3. Removable base.
4. Chargeable via cables or by standalone 18650 charger (in stock)
5. Hard Plastic Button so no more button issues.
6. Lights up white instead of blue.
7. Works with new Duals and standard Cartos
8. You can use a Go-go to 510 or a Go-go to 808D adapter on this also to fire your other cartos.

Now, this battery should last you a looong time, the battery is removable, so you can swap out "dead" batteries. I know this will hurt regular battery sales, but I am not in this just to make you spend your money so that's ok.
Please, based on what I have read and the limited amount that I know of batteries, use protected batteries in this item. I have tried it with unprotected batteries and it works just fine (as it should) but my recommendation is protected only.


Go-go Dual Coil Clear Catomizer
1. Holds 3.5ml
2. 1.8-2.1 ohm
3. Great vapor.
4. IMO a better flavor in side to side compare
5. Hard Plastic Tubing, doesn't look like it will ever crack in normal use.
6. Doesn't leak (so far)
7. Go-go Drip Tips FIT!!!!

I am going to leave the overall impressions up to you all as I am biased and I want to see this succeed. I randomly tested a few and they all seemed consistant, but please let me know if these fall short in any way.

I am going to do some more testing today, open a few up to see the guts and then I will start packing up the orders.
All Pre-orders will go out in the morning on Saturday.

 

[mohawkx]

Eric,

I can't stand the suspense. Let us know if both coils are located on the bottom of the carto so it will be possible to dismantle these and clean/dry burn them back into service.

 

[GoAskAl]

So Eric I know you are always looking for “new” products for the Go-go and when I heard from my brother Bill that he had come up with a way to dry burn his Go-go carts and sent me pictures I thought of you . To give you a little back story on Bill. He was always what you might call an eccentric, OMG what are you doing now, sort of an inventor/tinkerer who I always worried would electrocute himself, blow himself up or do bodily harm to himself.

I present to you the “Ultimate Dry Burner”. Just flip the switch and wait for the smoke to clear. It puts out +/- 6 volts and I think your Go-go to 510 adapters will work with it

​

 

[mohawkx]

Just got to say, that Eric is the man. Or as the Chinese maidens put it, "He is sex man, love you long time."

As most of you know I've had some problems with my lungs over the past few months and vaping for me was becoming quite the challenge. I have literally hundreds of dollars of juice I'll never be able to use and these will be coming up on the classified and PIF as soon as I catalogue them properly. The only juice I found I could tolerate was 0nic. Unfortunately, 0nic juice taste flat no matter what flavor you get it in. At least to me it does. I tried various vendors and various flavors and none would give me the satisfaction I required. Well, the VA took priority charge of my lung situation and provided me with the medicine I needed to restore some capacity and meanwhile Eric and I worked on some formulas and mixes that would provide me with vaping satisfaction and still preserve my lungs.
I am happy to state that I now have three juices custom made by Eric that provide total vaping pleasure and are very gentle on my lungs. The juices and formulas are listed below.

1. Berry Bomb. 1-30ml bottle at 0nic, standard flavoring mixed with Berry Bomb, 1-15ml bottle at 12mg nic, double flavor.
This combination gives me 45ml of Berry Bomb at 4mg nic with 1/3rd extra flavor. Verry satifying and flavorful with lots of vapor. Very easy on the lungs yet very full-bodied.
2. French Toast. Same mix as the Berry Bomb. Ending with 45 ml of 4mg with 1/3rd extra flavor. Magnificent taste, vapor and full bodied flavor.
3. Pina Colada Same mix as the others with fantastic results. I give each flavor an 11 out of 10.

I would highly recommend that those wanting to drop their nic level or are having some issues with their lungs from long term cigarette use give this custom mix a try as the full bodied flavor and the excellent vapor are there. Oh and these juices are very good with the cartos. They don't clog them up. I've been using the same bogelrs with these three juices for two weeks now and they are still going strong.

Thanks Eric, for taking the time to tailor make the juices and flavors that put me back on top with my vaping experience. You rock.

 

[gormly]

So Eric I know you are always looking for “new” products for the Go-go and when I heard from my brother Bill that he had come up with a way to dry burn his Go-go carts and sent me pictures I thought of you . To give you a little back story on Bill. He was always what you might call an eccentric, OMG what are you doing now, sort of an inventor/tinkerer who I always worried would electrocute himself, blow himself up or do bodily harm to himself.

I present to you the “Ultimate Dry Burner”. Just flip the switch and wait for the smoke to clear. It puts out +/- 6 volts and I think your Go-go to 510 adapters will work with it

LOL, I am pretty sure I wouldn't want to carry THAT! My name ain't Tesla!
Wow, that going the extra mile isn't it

 

[gormly]

I am happy to state that I now have three juices custom made by Eric that provide total vaping pleasure and are very gentle on my lungs.
.

That's AWESOME! makes my day to hear that!

On a sad note though, the Dual Coils are exactly where you'd expect in a filler carto, they are vertical and in sequence.
So I think the best course of action would be to keep them wet and clean them with water.

But you are pretty handy, maybe you can come up with something. I'll send ya a freebie if you want to take your try at coming up with something?

 

[GoAskAl]

LOL, I am pretty sure I wouldn't want to carry THAT! My name ain't Tesla!
Wow, that going the extra mile isn't it

I thought you'd get a kick out of that

 

[mohawkx]

That's AWESOME! makes my day to hear that!

On a sad note though, the Dual Coils are exactly where you'd expect in a filler carto, they are vertical and in sequence.
So I think the best course of action would be to keep them wet and clean them with water.

But you are pretty handy, maybe you can come up with something. I'll send ya a freebie if you want to take your try at coming up with something?

Not necessary to send me a free one. I've preordered three of them to play with so I've got enough to try them out and experiment. You've done enough for me at no charge. I feel that I owe you. No need to send any more freebees my way. Thanks for the offer though.

 

[gormly]

New Product Alert


Busy Day!!

XL3 18650 Battery Variable Voltage - Black
Fits most eGo and 510 Joye ego/510 series
Holds an 18650 battery up to 4000mAh (not included)

Change the voltage by pressing the button rapidly 4 times.

Variable Voltages:
Blue 3.0-3.2V
Pink 3.5-3.7V
Red 3.8-4.0V
White - Shutoff Off (yes, it's got a shut off)

This works with the 2.5LED and 3.5 Clearomizers and it's really nice with the variable voltage.

The XL3 is 101mm from bottom to top of screw and has a diameter of 20.5mm
As with the other XL's, You will need a 510 to Go-go adapter to use this with your Go-go cartomizer.
Battery not included.

It's got a inlay gold design on it.

This is a photo of the XL2 but it's exactly the same parts

The other side

You could easily paint this or otherwise decorate it as it comes completely apart into three pieces.

 

[GoodDog]

Cool! These would probably look really good with a wrap.

 

[Urge]

Eric, It appears that the new Go-go Jumbo battery is not threaded for a cone. The cones protect the carto from snapping off if you drop it. Why no cones?

Added...The original GoGos come off the charger at 4.2V why are the new ones only 3.7V? I get a better hit at the beginning with a freshly charged battery than I do at the end when the voltage is down closer to 3.7V.

Urge

 

[gormly]

The cones protect the carto from snapping off if you drop it. Why no cones?

I guess that's one reason for a cone, I never actually thought of that.
Why no cone? Not sure, forgotten about during back and forth design, manufacturer doesn't like cones.. I don't have a valid answer for you.

Added...The original GoGos come off the charger at 4.2V why are the new ones only 3.7V? I get a better hit at the beginning with a freshly charged battery than I do at the end when the voltage is down closer to 3.7V.
Urge

Well what I said previously was incorrect, it will go up to the charge of the battery apparently, I just pulled a slightly used 18650 off the charger, put it in and I am getting 3.99- 4.1v
I had asked that they make the electrical behave exactly like the Go-go standard battery, and it seems they did.

I have to get some more information from the manufacturer, like exact details on the circuits. I'll post when I know, but this is good news.

 

[gormly]

Updates:


First the dual coils are awesome in my opinion, side by side I seem to get a bit more flavor and vapor.
I do so much testing it's not even funny so I will leave it up to you all to provide the actual reviews but so far, I really like them.

Second the Jumbo Battery seems to work very well with regular Go-go cartos, but I have had a slight issue with the new Dual Coils. Sometimes they do not fire and I have to take it off and reseat. I popped up the center post and it worked fine, so oddly enough the new Jumbos seem to have the old problem but only with the dual coils. They fire every standard Go-go I throw at them.

I have gotten as much as 4.1 on a new 18650 battery, but so far hasn't gone below 3.7 during use, so it also seems this functions exactly like a Go-go battery.

All pre-orders are sent out and in the mail...