Official DiscountVapers.com Thread

Status
Not open for further replies.

gormly

Unregistered Supplier
ECF Veteran
Jun 9, 2011
4,504
7,464
Connecticut USA
www.discountvapers.com
Eric, are all go go kits in stock? It says they are on the site but I coulda sworn you mentioned something about kits a few pages back and I'm too tired to look...thanks :oops:

Yes, just the black is missing cones, but I will have them hopefully by Friday.
Stainless and the colors are in stock as of right now, although I don't know how.. I sold almost everything this Monday :)
 

Urge

Super Member
ECF Veteran
Aug 7, 2011
403
245
Shrubburbia Ma.
Eric wrote...
Try not to remove the center post

How would you deal with this without removing the centerpost? Trying to resolder the wire way up inside there has to be an incredible pain in the ..... USPS says I will be getting a pass thru and another battery(unfortunately Eric was out of the batteries with the led-bummer) tomorrow so I am coping with only one battery. I have to charge up my battery every night now even though it still had life left. I was down to one bar and I think I was at around 750 hits on the led. I am at 480 right now so I might be less than 700 tonite when I put it on charge just before I go to sleep. Is this going to affect the effective life of each charge? Previously I never charged it until it blinked 15 times.

Urge
 

gormly

Unregistered Supplier
ECF Veteran
Jun 9, 2011
4,504
7,464
Connecticut USA
www.discountvapers.com
the batteries are suppose to have no memory effect or any detrimental issues like old batteries used to so I am petty sure you are safe.
I throw batteries on the charger all the time, empty or not, right before I go to bed I put 6 batts on a charger setup, rinse repeat, I've used the sames batteries for months now. I can't remember the last time I saw one blink :)

and yes, soldering up inside is indeed a pain but it's possible.
 

GoodDog

Vaping Master
ECF Veteran
Verified Member
Dec 31, 2009
4,160
1,008
SF East Bay
Thank you for super fast shipping. I got some dual-coal go carts. What is the best method to fill?

I find it best to use a syringe with an 18g pointed needle or the bottle caps Eric sells with a luer lock needle. I move the needle around and up and down as I squirt in the juice until it starts to come out the bottom of the carto. Sharp needles are easier to get between the filler and the plastic tube than blunt tip needles.
 

gormly

Unregistered Supplier
ECF Veteran
Jun 9, 2011
4,504
7,464
Connecticut USA
www.discountvapers.com
Eric wrote...

So, are you saying it's easier to solder the center post inside of the battery cap than it is to replace the center post? Would you take out the circuit board?

Urge

Most likely I would take it out, it depends on where the break or short is. The circuit board is soldered in on the right side in a notch groove if I remember correctly, if you desolder that it pops out.

Thank you for super fast shipping. I got some dual-coal go carts. What is the best method to fill?

I do it the same way GoodDog does, but with a blunt needle tip on a syringe, makes it easier if you orient the blunt side toward the tube.
 
robotevil wrote...

The plugs are the plunger on a 3ml syringe. Here is a link to where you can buy them. Animal Health Express

they cost 18 cents each. I have noticed the same thing, the rubber on the stoppers degrades over time.

Urge

Mine were degrading as well, ordered some of these and they work perfectly, thanks for the link Urge!
 

NC_Fog

Super Member
ECF Veteran
Verified Member
Apr 29, 2011
644
1,167
Central N.C.
I received my GGDCC's today and all I have to say is WOW!!! Eric, you nailed it with this one. I recently reduced my nic level to 10mg from 18mg and getting somewhat used to it slowly. I put some of the 10mg in the GGDCC and it made me cough due to the choking vapors...lol. This was followed immediately by a nic buzz that numbed the back of my head. Nice warm vapor much like an analog. Good Job. I hope you continue to have these available, I will be ordering more of these.

Martin
 

gormly

Unregistered Supplier
ECF Veteran
Jun 9, 2011
4,504
7,464
Connecticut USA
www.discountvapers.com
I received my GGDCC's today and all I have to say is WOW!!! Eric, you nailed it with this one. I recently reduced my nic level to 10mg from 18mg and getting somewhat used to it slowly. I put some of the 10mg in the GGDCC and it made me cough due to the choking vapors...lol. This was followed immediately by a nic buzz that numbed the back of my head. Nice warm vapor much like an analog. Good Job. I hope you continue to have these available, I will be ordering more of these.

Martin

I already put in a new order, can't believe I went through almost 1000 :)
 

taterbugg

Senior Member
ECF Veteran
Verified Member
Oct 20, 2011
174
199
60
Lansing, MI
I think these are going to be unreal once I get the tobacco flavors released, I really think it will be the closest yet to analogs, we'll see :)

I have been anxiously awaiting this since you first mentioned it. I like some of the other flavors occasionally, but I still like my tobacco based flavors for my all day vapes.
 

taterbugg

Senior Member
ECF Veteran
Verified Member
Oct 20, 2011
174
199
60
Lansing, MI
I am just as anxious, sorry I can't make it go faster, some of this needs time to work otherwise I'll get a poor result.

No need to be sorry man! :) Not trying to rush, just knowing the way you do things....I'm excited to try out your tobacco flavs!!! .........so hurry up! :p
 

gormly

Unregistered Supplier
ECF Veteran
Jun 9, 2011
4,504
7,464
Connecticut USA
www.discountvapers.com
Ready to place an order but I reallly NEED that Go-go to 510 adapter and I'd like to get it all at once. I did look back in the forum a bit, and you said 'soon'....any more word on how soon? :confused:

it's in the air, I asked for tracking, haven't heard back yet but he is reliable (most of the time)
 
Status
Not open for further replies.

Users who are viewing this thread