Printed DNA 40 Bottom Feeder Mod
- Thread starter gdeal
- Start date
- th_trl_thread_readers 0
- Status
Kurrpt I don't think anything else could go wrong for you! You get the "Persistence Award" for sure! I sure wish you earn the "Most Likely to Succeed Award" as well!
- Pauly3
- Pauly3
no paul (my name is also paul), I don't think much else could go wrong at this point but then again, I didn't try to bottom feed-convert any of my RDAs yet so there is still room for mess ups lol
I'm optimistic that when my new board comes I'll be good
I'm optimistic that when my new board comes I'll be good
Well I finally got it done! vaping it now, and the temp protection is working well. My only problem is my button sticks. I had it apart and sanded the sides of the button and the button port, it's better, but it still wants to stick when the top cap is all the way on. So I have to pull it up a bit, and it works. I guess I gotta take the top cap apart again, but I've had enough of it for a while 
Well I finally got it done! vaping it now, and the temp protection is working well. My only problem is my button sticks. I had it apart and sanded the sides of the button and the button port, it's better, but it still wants to stick when the top cap is all the way on. So I have to pull it up a bit, and it works. I guess I gotta take the top cap apart again, but I've had enough of it for a while
My guess is that the Tact or Alps switch is not positioned well with the button, that has been known to make the button stick as well
Silly question, im going to try my hand first time building v4.2. Ill have my printed parts next week, On the hardware kit i ordered from livewire the small o ring and large one, where do these go? I dont see any mention of them in the build pdf.
the small one goes between the vented screw and the 510 delrin, the larger one can go on top between the atty and the 510
Thanks for the info guys, I'll check it out. Here's a couple of photos. The ridge line is visible through the dye on one side.
Anyone know were a replacement large screen can be purchased, other than from Evolv? I have a RMA request in for the one I am having a ribbon problem but also would like to see if there is an alternative route just for the screen.
you guys were right, i had to re-seat the switch and bingo, perfectly functioning button. thank you.
That's a freaking bummer. I hope they send another. Or find yours. I just ordered a Gdna 2 days ago. Gonna put a DNA 40 large screen in er!
-Mark
That sucks for sure. I am willing to bet they will make it right though.
Any package I receive worth more than a few bucks gets opened on video. I am paranoid about having proof if something should happen to be wrong, or missing entirely.
I make sure the camera gets a clear shot of any labeling, along with a quick view of all sides of the package to show I haven't tampered with it yet. I make sure it stays in frame at all times while opening it as well.
Overkill? Maybe, but I would rather be safe than sorry.
- Status
Similar threads
- Locked
