Printed DNA 40 Bottom Feeder Mod
- Thread starter gdeal
- Start date
- th_trl_thread_readers 0
- Status
You can get the small screen direct from Evolv, it's in stock.
nice.
I have an RMA from them for my current one. I was just hoping to get one quicker than the whole process through them
Just because you are doing a RMA with them doesn't mean you can't place an order as well. Completely separate things.
I'm in the final steps, gonna finish up today, and I had a small problem with my button. I'm using the Alps switch, and every time I put the completed top cap on the body, the button would fail; it was being pulled too tight by the magnets. So I removed the 2 mags out of the body that were nearest the button, and it fixed the problem. Just thought I'd pass that on.
I gave up on the Alps after "loosing" 3 of them in Beta stage and have only used the ball tact switches since. Heck, 1 didn't work at all.
My last RMA a couple weeks ago was surprisingly fast. I think they had it back to me in a hair over a week.
Anybody having problems with the large screen DNA40? Mine works when not in the body but goes out each time the unit is assembled. I was able to trace it down to the ribbon cable - when the up/down wires are in the little pocket it applies pressure to the ribbon causing it to go out. The device still works but the display is dead. Sounds like a RMA is in my near future.
While assembling the GDNA took about three hours longer than thought it wasn't too bad at all. Only thing I really want on future releases would be to have the atty sit at the way down flush with the mod. My 510 is tightened down all the way and still can't get my Freakshow Mini or Derringer to sit flush.
While assembling the GDNA took about three hours longer than thought it wasn't too bad at all. Only thing I really want on future releases would be to have the atty sit at the way down flush with the mod. My 510 is tightened down all the way and still can't get my Freakshow Mini or Derringer to sit flush.
Last edited:
only thing I could guess is out of the body, it's easier for the battery to make contact. perhaps the top cap isn't flush enough to make a good battery connection
Good ideas! I should have put it aside to clear my head instead of banging my head. I think adjusting the delrin will do the trick as I know it is tightened all the way up as well.
I think the screen is bad as it will fail even out of the mod with the lightest of touch to the ribbon cable.
Sent from my iPhone using Tapatalk
Anybody having problems with the large screen DNA40? Mine works when not in the body but goes out each time the unit is assembled. I was able to trace it down to the ribbon cable - when the up/down wires are in the little pocket it applies pressure to the ribbon causing it to go out. The device still works but the display is dead. Sounds like a RMA is in my near future.
While assembling the GDNA took about three hours longer than thought it wasn't too bad at all. Only thing I really want on future releases would be to have the atty sit at the way down flush with the mod. My 510 is tightened down all the way and still can't get my Freakshow Mini or Derringer to sit flush.
Anything that keeps s person from getting their freakshow on needs to be addressed.
Sorry, nothing personal, I just wasn't able to let it go by, my filter hasn't kick on yet this morning.
how do you guys "lock" the screen from sliding around in the bottom internal piece?
Once screen cover/pos terminal is on, screen will be locked, the idea is to hold screen in plkace while sliding the cover over it
No, once you install the screen and slide the positive battery piece on the screen will stay in place.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- Status
Similar threads
- Locked
