Protege question

[nomochokes]

Just wondering if anyone knows or has an opinion on which atomizer would work the best on the protege. The 801, 901 or the 510? I currently use an 801 on my PT and I really like it but may try another type if it might perform better with the Protege.

Thanks for your imput!

 

[lotus14]

It comes down to personal preference. If you have a PS passthrough you're running your 801 at 5v.

IMHO, the 510 vapes better than the other an 801 at 3.7v - the Protege's voltage.

 

[kardjunkie]

It comes down to personal preference. If you have a PS passthrough you're running your 801 at 5v.

IMHO, the 510 vapes better than the other an 801 at 3.7v - the Protege's voltage.

I would agree, I like 801 at 5v but 510 is really nice at 3.7 but as lotus said it's all PERSONAL PREFERENCES. Caps not to be a jerk just to emphasize it.

 

[vapn]

Yea if I were to order a Protege it would most definitely be the 510. That little atomizer is a work horse at 3.7v. And really kicks .... at 5v. and 6v is not so good IMHO. I ordered some HV juice to try that so we shall see if that changes ...

 

[NekoGurrl]

I have to agree, the 510 is much better at 3.7 volts than the 801. Have both a 510 and 801 Prodigy, originally planned to get the 510 without resistor for an 18650, but really like it at 5v.

So I ordered the Protege for the 510 at 3.7. Even ordered some stainless atomizers to go with it.

It is a little workhorse! And of the 5 original 510/Dura atomizers I got 4 months ago, only one has burnt out.

 

[Gotcoffee]

510 was my pick. But I also got a 801 adaptor. There is days were I just prefer my 801 over my 510 at 3.7v. But if I only could pick one it would be 510.

 

[Gibby]

It comes down to personal preference. If you have a PS passthrough you're running your 801 at 5v.

IMHO, the 510 vapes better than the other an 801 at 3.7v - the Protege's voltage.

Just a bit of clarification. The 801 actually runs a little over 4v under-load on the PS PT. The output is usually 5v depending on the USB port.

*Correction it runs at about 4.3V under-load

Gibby

 

[CaSHMeRe]

Just a bit of clarification. The 801 actually runs a little over 4v under-load on the PS PT. The output is usually 5v depending on the USB port.

*Correction it runs at about 4.3V under-load

Gibby

Gibby getting her voltage load tests done ... I'm liking it

I prefer the 510 on the Protege ... Then 901 ... Then 801 ... in that order.
PT/Prodigy ... 801 ... then 510 .... then 901 .... in that order