Do they double as weights? Probably work pretty good for still fishing.
Last edited:
- Status
Do they double as weights? Probably work pretty good for still fishing.
Have you guys seen Imeo's AVS V3 yet. I know I am going to like the ProVari better but the GGTS with the AVS V3 is a mechanical work of art. Only thing it seems complicated and temper mental.
Last edited:
Pete is right. The efficiency is very high and not much energy is lost. Nothing on the board gets hot
Hey guys, I'm a bit behind in the thread, anyone using the eGo-T on the ProVari? Is it worth trying out? Do I need an adapter to use it? I've been using the high-tech stuff for a while, figured it was time to try something less expensive...
Yes
Yes
Yes... I made mine out of a 510 connector and burned out carto... pretty easy... cut the carto tube to 3/8", cut the skirt off a 510 battery connector, leave the silicon ring, remove the center pin... press that into the tube so the center pin of the carto connector slides into the silicon ring of the battery connector... voila'... perfect adapter!
Hi Guys just got an error code "OP" any ideas what this one is?
That stands for "Ominous Power" ... It's for use ONLY by professional chain vapers...
Cliffy,
In the ProVari Owner's Manual, page 13, it says:
ProVari Atomizer Ohms
In this mode the ProVari will read and display your atomizer's ohms measurement. This feature is useful if you want to check what type of atomizer you have installed. If you enter this mode with no atomizer installed the display will read OP meaning "Ohm's Pending" as it cannot read the measurement until you insert and atomizer/cartomizer.
HTH,
Ginnie
In the ProVari Owner's Manual, page 13, it says:
ProVari Atomizer Ohms
In this mode the ProVari will read and display your atomizer's ohms measurement. This feature is useful if you want to check what type of atomizer you have installed. If you enter this mode with no atomizer installed the display will read OP meaning "Ohm's Pending" as it cannot read the measurement until you insert and atomizer/cartomizer.
HTH,
Ginnie
Yes... I made mine out of a 510 connector and burned out carto... pretty easy... cut the carto tube to 3/8", cut the skirt off a 510 battery connector, leave the silicon ring, remove the center pin... press that into the tube so the center pin of the carto connector slides into the silicon ring of the battery connector... voila'... perfect adapter![/QUOTE]
If you don't want to do that you can get 2 510-510 connectors from avidvapor and stack them. It will leave a gap of 1/4 between between the skirt of the ego-t and the battery housing. It looks good IMO and works well at 3.7 volts.
cheers,
If you don't want to do that you can get 2 510-510 connectors from avidvapor and stack them. It will leave a gap of 1/4 between between the skirt of the ego-t and the battery housing. It looks good IMO and works well at 3.7 volts.
cheers,
Well you could you use the $1 510 battery extender (7/8"). It's a little longer than 2 Avid adapters stacked (1/2"), but it performs the same function.
PV Adapters
Last edited:
- Status
