If I'm using readyXwick. I'm assuming I need to use a longer piece then what I use in the RM2. I doubt anyone has pics of an RM4 with Readyx wick?
Questions on RM4
- Thread starter jamesfarrell
- Start date
- th_trl_thread_readers 0
- Status
Yes it is, currently out on loan. Yes it is slightly angled down on the long tail side. That is during a rinse, dry burn session. After I put the top on and squonk to get the wick wet I tuck the tails down with a luer lock needle.
I'm assuming you bent the legs like that too so you can line the coils up with the air holes properly? I hope I like this thing, it's on the way. Thanks for the responses hoss.
When I build the rm4 I put the coil high legs in the center post and the coil low legs in the negative posts. That puts the coils at a natural 30 deg or so angle downward to the center without bending the legs. Also allows you to adjust coil height for throat hit by just turning the cap a little. YMMV
Yeah a little OCD about prebending the legs so that the coil wraps don't get pulled out of shape while mounting
- Status
