RBA testers Needed.

Status
Not open for further replies.

Vcoupe

Super Member
ECF Veteran
Verified Member
Apr 23, 2013
323
534
Gotham
Still banging away at the prototypes. May have them done later tomorrow.

I should mention again, i'm not looking for reviewers, im looking for people with rba experience to experiment with different coils, wicks gauges etc to find their optimum setup and give that feedback to super-t and when released to the general public, share their experiences, setups etc with new users. Being active prior to this thread on the Super-T subforums is a big plus as I want people who are around to help others when its released.

:) ready if you are .
 

forcedfuel50

Unregistered Supplier
ECF Veteran
And consider that they run within the walls of the piping hot body.

Yes, once the atty warms up, it preheats the air, much like a heater core as we route the air through the top body and side body walls passages. They aren't just holes that dump into the atomizer, the air flows through machined internal passages. You can fine tune the draw and warmth of the vapor by adjusting the airflow. And let me tell you, this adjustable draw works flawlessly with true minute adjustments being able to be made.
 

9ball_AJ

On the Snap...
ECF Veteran
Verified Member
Speaking of piping hot, I was in a Greek restaurant in Fairbanks yesterday before my flight home. The brass bar attached to the bar was heated... purposely. My hands were grateful as they warmed up quickly as I waited for my lunch. It's the little things that make all the difference sometimes...
 
Status
Not open for further replies.

Users who are viewing this thread