rDNA want TC off-please help

[chanelvaps]

Does anybody know how to turn the temp control off in these darn things? I want to use mine in regular mode and it has somehow gotten itself in TC mode. HELP

 

[smokewell]

If you turn the temp up or down you will reach the off setting.

 

[jmarkus]

lock the mod by clicking fire button 5 times. hold down the up and down buttons to change temp. scroll up past 600f to OFF. that should do the trick.

 

[csAdams]

lock the device.
hold the up and down buttons go all the way up

 

[chanelvaps]

thank you both. I've got it! YAY!

 

[ThunderDan]

You can leave the temp set and use a kanthal coil on a dna40. It doesn't hurt anything. If the dna40 doesn't detect a change in resistance when fired it doesn't attempt to do temp limiting. You can see this on the device when you fire it the temp will change to blank when using a kanthal coil.

 

[chanelvaps]

I am using kanthal and it usually fires in regular mode (non TC) but for some reason it got set to TC and I could not get it off

 

[puffon]

DNA 40 instructions:
http://www.evolvapor.com/datasheet/dna40.pdf

 

[VapingBad]

DNAs don't have separate modes under the surface they are smarter than that, just trust it and it will work it out as @ThunderDan said.

 

[chanelvaps]

so are you saying just use it and it will figure it out?

 

[chanelvaps]

so are you saying just use it and it will figure it out?

As in I cannot be in the wrong mode?

 

[VapingBad]

As in I cannot be in the wrong mode?

Yes, it will only temp limit if it senses the wire changing resistance enough. You can turn temp limiting off for Ni200 but there is no need for Kanthal it won't try to do it.

 

[chanelvaps]

Good to know. Since you know so much about it the rDNA, how about the temp protection, where does one generally want it set? It was set at 450 when I got it and during all of this fiddling around I managed to set it to 600

 

[VapingBad]

I like 380 F, 420 is probably a good place to start and adjust until you get the best flavour with enough vapour staying as low as you can, if you have to go over 450 F you probably need more airflow or contact area on your coil.

 

[chanelvaps]

wow! Adjusted mine to 380 and much better and cooler vape