Status
Not open for further replies.

Capt' Brian

Unregistered Supplier
ECF Veteran
I don't know if you are interested in any of mine but you certainly have permission if you want to. Also, Cappy, I just wanted to say how amazing the tolerences on the door is. It slides into place with such ease, but there are absolutely no rattles or movement. Great job!

Very happy your happy! As for the rattle, I found I had made them a bit TOO tight last batch, had a couple minor problems so I loosed up the tolerances a bit and also looked at what kind of wood it was made out of and adjusted for that too. Some wood expands and contracts more than others, so on a hot & humid day the door might stick. I think I'd rather it be too loose than too tight. The dense woods are sometime more prone to that also, less room in the grain for it to expand from humidity changes.

If a door does stick too much, just a few swipes with some fine grit sandpaper along the door edges should loosen it up again.
 

Landlord

Vaping Master
ECF Veteran
Verified Member
Jan 30, 2011
6,357
5,040
44
Cleveland Ohio
Here ya go.. had to part with one so I'm down to only one cutlass now.. that should change soon...lol
 

Attachments

  • 20120820_223427.jpg
    20120820_223427.jpg
    21.8 KB · Views: 44
  • 20120820_223257.jpg
    20120820_223257.jpg
    23 KB · Views: 41

Capt' Brian

Unregistered Supplier
ECF Veteran
Here ya go.. had to part with one so I'm down to only one cutlass now.. that should change soon...lol

A rounded edge Dreadnaught? You have a round Dread? How did you get a round dread? I don't remember making a rounded dread.... hmmm .. did I?
 

Landlord

Vaping Master
ECF Veteran
Verified Member
Jan 30, 2011
6,357
5,040
44
Cleveland Ohio
Nice fleet LL. I know that is only a fraction of the whole collection. That whole collection you have is impressive. I gotta see it again, LL. Gotta update my fleet's pic also.

Some of that original collection went to friends and family that i finally talked into vaping and a lil of it sold.. kept all the faves then added more shiny stuff..
 

TheBigD

Senior Member
ECF Veteran
Verified Member
Nov 16, 2009
110
13
I think it's zebra wood and tiger something. It was one that Cappy put up on the site that had already been made. I put in an order for a custom that would have been about the same, but in reverse. So I fired off an email to cancel my custom and send the one that's finished, and Cappy did it lickety split!

I plan on posting pics when it gets here.
 
Status
Not open for further replies.

Users who are viewing this thread