Reo compatible RBAs
- Thread starter hildicat
- Start date
- th_trl_thread_readers 0
-
- Tags
- evic fasttech mt baker myvaporstore
- Status
They will not automatically redeliver. they will leave a 2nd notice on day 3. If you do not pick it up at the PO or schedule a redelivery it will be returned on the 5th day.
When you get the first notice just go online and schedule delivery for Saturday.
a few pages back in this thread there was some discussion about the A6S. just saw this:
New ! Kumiho A6S Stainless Steel Rebuildable Dripping Atomizer [01-K-4-2] - $5.99 : Healthcabin Electronic Cigarettes - Wholesale and Retail
New ! Kumiho A6S Stainless Steel Rebuildable Dripping Atomizer [01-K-4-2] - $5.99 : Healthcabin Electronic Cigarettes - Wholesale and Retail
The Divo says it is 22mm. But it looks the same size as a cyclone you can also get it in BF option. Has anyone tried it with a non milled reo. Or is it only for reo that are milled.
A milled Reo = Low Profile (LP) Reo, meaning some 3 mm has been milled from the catchcup of a standard Reo. This is to accommodate a wider variety of atomizers, which have been modified for bottom feed. For Example, the Cyclone bottom fed atty fits the standard Reo, but with the AFC (Air Flow Control) cap on it does not, but the LP Reo can take the Cyclone, with or without AFC cap.
Yeah, that caught my attention as well. The Patriot is 22mm, the std Cyclone is 15mm and AFC top is 18mm
turbocad's post from another thread:
here's both side by side, cyclone is on an 18mm base, divo is on a 14mm base
Yeah he also said it's about 14mm and that the Cyclone AFC cap will not fit as the Cyclone base is slightly larger.
Thanks so much. I am going to order it. It works well with the grand or are they any hickups I should know?
I think it works just fine. The airhole is a bit low, so if you drill it out, be aware of leak potential. Haven't had it leak on me, but the possibility is there.
I'm beginning to be convinced that it is worth the extra $ over the RM2. I'm still not a fan of the hex posts, or the post positioning, but I really like the flavor.
Sent from my mobile
I'm beginning to be convinced that it is worth the extra $ over the RM2. I'm still not a fan of the hex posts, or the post positioning, but I really like the flavor.
Sent from my mobile
I replaced the hex screws in my Cyclone with spares that Rob sells for the RM2, they might also work in the Divo
I'd read that before. Just tried it. Now I do prefer this over the rm2. I'd probably still recommend the rm2 for newbs, but I like the flavor and the press fit of the divo.
On the cyclone, is the afc cap set up with two airholes? This post setup, esp with the juice hole being through and through, seems ideal for running dual coils. I don't think I have the setup to properly drill a second hole in my divo cap, nor would I want to be required to run duals. But it'd be nice to have the option. A lp grand and cyclone afc are my current wish list items. Well, maybe a mech woody. A lp mech woody with cyclone. Ok. New dream confirmed.
Carry on.
Sent from my mobile
Yes it has two and it can be setup so it can also run a single coil with a single hole open that still has airflow control.
Yup. That cinches it. I *want* a lp mech woody. Failing that, a lp grand. And a cyclone afc to go with.
Sent from my mobile
- Status
Similar threads
