The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

Review 510 PCC Problems: Case Slots Aren't Deep Enough; Cartridges Fly Out

Discussion in 'Requests for Opinions/Reviews' started by lusayalmino, Nov 13, 2011.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. lusayalmino

    lusayalmino Senior Member ECF Veteran

    Oct 31, 2011
    The e-Cigarette 510 PCC Personal Charging Case is a great product (see pics and review here). Many vendors carry similar versions of this case, but there is one flaw I've run into.

    Whenever I'm out and about, the cartridges will fall out of their slots and the 510 cartridges will jump all over the place:
    Buy eSmokeClub Case 510 PCC 16.jpg

    This is becuase the rubber slots are not deep enough:
    Buy eSmokeClub Case 510 PCC 17.jpg

    Any ideas on how to fix this problem would be greatly appreciated!
  2. lusayalmino

    lusayalmino Senior Member ECF Veteran

    Oct 31, 2011
    I wanted to get a 2nd rubber inlay and put one on top of the other; but upon contacting the vendor, they were unable to oblige.

    But I found another fix:
    1. Purchase Heavy Duty Felt
    2. Cut a piece the same size as the rubber inlay, but only wide enough to cover the 6 cartridge slots (don't want to block the battery slots).
    3. Reassemble and that's it! Benefits:
    • Cartridges will no longer fall out, fly around, rattle and make noise, etc.
    • Do not peel off the sticky backing; there's no reason to do that and you'll be able to pull everything out to clean the inside.
    • Purchase a color felt that looks nice with your case.
    • The nice thick felt 'carpeting' will absorb e-juice and keep it out of the PCC Charger's insides.

    Buy eSmokeClub Case 510 PCC 19.jpg Buy eSmokeClub Case 510 PCC 18.jpg

    By the way, simply finding a way to raise the rubber inlay -- without having a 'floor' underneath -- will not work. If you are using flat butterfly tip cartridges, they must go upside down; your cartridges and cartridge caps will catch on the bottom of the rubber inlay get pulled off. This method solves that problem.
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice