"RING-O-LED" 510 magnum

Status
Not open for further replies.

tdstrike

Super Member
ECF Veteran
Mar 22, 2009
505
0
base of the Wasatch, Utah
I will give you all that, and I will put a different color LED in every hole...........Deal?



Cisco...
Nahh, you'd prolly ship out your unemployed 18 year old nephew just so you could put a mill in the basement, I went with a 510-IT RAWKS!!!!!!!So much vapor, my neighbors called Red Addair to put the fire out and a throat hit like a machette going through your spinal cord.

Nice mod though, you show great promise:D
have you seen that new upstart company that put a vaping device in a small laser-my word.
 

Bubo

Super Member
ECF Veteran
Yous dun it again Cisco.. :) great work!

I gotta ask though - in picture #2, the close up of where the atty connects... What are you using for that "Bushing - Brushed Aluminum" chrome part? Another one of your milled products or something that us mere mortals might find somewhere?
 
Last edited:

Cisco

Unregistered Supplier
ECF Veteran
Apr 13, 2009
526
101
NY, State of denial
www.avidvaper.com
Yous dun it again Cisco.. :) great work!

I gotta ask though - in picture #2, the close up of where the atty connects... What are you using for that "Bushing - Brushed Aluminum" chrome part? Another one of your milled products or something that us mere mortals might find somewhere?

Thanks Bubo...:)


I used a "Hewlett Packard 57 10a dual column gas chromatograph with flame analization detectors" and yes, it is Turbo charged............:D


Actually its a piece of aluminum machined and polished to a chrome finish. It's about 10mm (3/8") thick and it is pressed into the housing and the connector is pressed into the bushing. The connector is also recessed to create a sort of juice well. It is indestructible and extremely rigid. You don't need any finesse, you can crank the atomizer on without ever worrying about the connector spinning or coming out. Also because its a press fit there is no need for a separate ground wire.


Cisco...
 
Status
Not open for further replies.

Users who are viewing this thread