Thanks classwife... I like those dapping blocks. I kind'a made my own by dimpling a block of wood with my metal shaping hammer (ballpein end) then used it to shape the washer. The washers Im using are 20¢ each, wood was scrap, and the hammer from my fathers tool box guess Ill skip the steel for now, but I think it would certainly work better.
Scubagen Mods
- Thread starter UA72Riddle
- Start date
- th_trl_thread_readers 0
- Status
Thanks classwife... I like those dapping blocks. I kind'a made my own by dimpling a block of wood with my metal shaping hammer (ballpein end) then used it to shape the washer. The washers Im using are 20¢ each, wood was scrap, and the hammer from my fathers tool box guess Ill skip the steel for now, but I think it would certainly work better.
I think you're right... want to change the coils on the 34g then... may be time to change gauge again.
who what Dan you say a mini? I love the small ones. heck anything that will hold 1.5 - 2 ml would work for me.
1 85385T885 1 Each Corrosion-resistant Type 304 Ss Wire Cloth, 400 X 400 Mesh, .001" Wire Dia, 12" X 12" Sheet
McMaster-Carr
McMaster-Carr
Ok will be working on DSUv4 here soon, will post results as I go...
Concept Pic:
Bottom:
Top:
Dan
Concept Pic:
Bottom:
Top:
Dan
Last edited:
Turbo, I don't have that link, but do you know that if you buy threaded rod to fit the hole, you will have to grind it down to fit the spring and washers? That's why I never even looked and decided the nails\metal carto tubes were groovy. UA72Riddle may have the link though.
Uhh, ?? ,,,,,, what about "equilibrium"?
Am I missing something? what stops the juice from seeking it's own level between tank compartments?
I don't think those are compartments. I think it is open all the way around. Both pieces are cylindrical.
Looks like 2 cylinders. Heating coil/wick in the inside cylinder and Juice on the outside. some small hole to get to the wick that is in the inside cylinder. If the wick is porious enough to wick then the 2 compartments will seek "equilibrium.
Or I missed something,,,,,,,,,
Last edited:
I don't even see how the wick gets wet..... We apparently need more than just a picture here..... Are the black dots O-rings?
Except that is v3 and Dan is currently on v4. I do not know what changes are being made to v4 as of yet.
Actually it looks like the coil will not be secluded from the main body. It looks like it's o-ringed into the center tube and accessed easily by unscrewing the bottom.
Actually it looks like the coil will not be secluded from the main body. It looks like it's o-ringed into the center tube and accessed easily by unscrewing the bottom.
Last edited:
Yeah it called a vacum
Air has to travel the passage way to release liquid to the vacum created.
Dan
Last edited:
Yes, think of an upside down T, that is the passageway for the juice to travel. The top of the T inverted has SS mesh inserted into it, the wick set ontop of that allowing the juice to flow upwards to the coil.
Dan
Only two tubes and two main metal pieces, as opposed to 3 tubes and 4 metal piecs used in v3
Dan
- Status
Similar threads
