Should I trade my plenty of vtc4 for more Panasonic PF's

[LReyes66]

I have plenty of vtc4.. About 7 and 2 Panasonic 18350PF. My friend is almost the opposite of my situation.

I only use my mech mods and only use my authentic Russian91 or KFL+ and the lowest ohm I tend to build is .7 since Im not a dripper. So I might as well get rid of some of my vtc4 right?

Also while I'm at it, when I use the ohm calculator... When I input the volt (4.2) and ohms whatever the amps that puts out should be the kind of amperage my batter has too out out right? For instance with my input of 4.2v and .7 ohm the amp is 6. So if I use my Panasonic PF that has a constant output of 10a(ignoring the 5sec burst of 15a), that means I'm still under my batteries limit by 4 amps right?

Sent from my Nexus 5 using Tapatalk

 

[KenD]

But why would you want to? The PFs are good batteries (I have several), but even with a higher mAh rating they don't give much more vape time than the vtc4s. Also, the internal resistance of the vtc4 is much lower, which translates to less of a voltage drop in a mech mod.

Sent from my GT-I9100 using Tapatalk

 

[Paul.K]

^^^^ This. The vtc4 is a great battery especially for mechanical mods. I have the Pana PD' s and find them to be more suited for my regulated mods.

 

[KurrptSenate]

I wouldn't

 

[LReyes66]

But why would you want to? The PFs are good batteries (I have several), but even with a higher mAh rating they don't give much more vape time than the vtc4s. Also, the internal resistance of the vtc4 is much lower, which translates to less of a voltage drop in a mech mod.

Sent from my GT-I9100 using Tapatalk

i see. I figured since im not really going subohming bellow .6 that both I wouldnt be really using the VTC4 to the fullest and PF would be just as good with longer run time.

 

[fasteddie5]

Hell to the no!