Oh, the GG guys would kick ..... dspin probably has enough top tubes to run ten stacked 18650s.
Looks a helluva lot better, too!
But I'll bet we're all shorties compared to what vaptamist comes up with.
![]()
Touchwood Mini with 18350 battery inserted positive side up
No it did not work without an adaptor. I wrapped it with a carbon fiber ring I have that just fit perfectly.
MY NOTES: It is difficult getting a Kick in and out. Naturally, since it has to be a snug fit. DO NOT PULL on brass contact...it can and will come off and be a ..... to find on your floor. Instead, if you must do something other than finger pulling or sliding it out, use a needle nose and VERY VERY gently work it out using the blue pot to grab onto and turn it circularly until you can VERY GENTLY pull it out. Leave it in whenever possible to save wear and tear.
Uh, the blue pot/block is how Kick #1 was destroyed .... LOL It will crack and sort of collapse on itself when grabbed.
On mine, the threads are the big hang-up. I tried to sand them down a bit between Kick 1 and Kick 2 but that didn't make much of a difference. I don't like the idea of it being irretrievably shoved in there, it makes me want to take it out for that reason alone. LOL
I getcha. Part of the Kick's appeal is its transportability. For me though, since I vape P+s almost exclusively, that portability is just a PIA. Having the Kick forever entombed in a convenient P+ extension is the shnizz.Uh, the blue pot/block is how Kick #1 was destroyed .... LOL It will crack and sort of collapse on itself when grabbed.
On mine, the threads are the big hang-up. I tried to sand them down a bit between Kick 1 and Kick 2 but that didn't make much of a difference. I don't like the idea of it being irretrievably shoved in there, it makes me want to take it out for that reason alone. LOL
For me though, since I vape P+s almost exclusively, that portability is just a PIA. Having the Kick forever entombed in a convenient P+ extension is the shnizz.