Now I typically run 50/50 pg/vg...haven't had an issue...
I'm really loving these square bottles, I love the extra capacity and the feel of the flat surface when squonking. Most devices have been converted over, including a Grand with the 9ml Japanese bottle, no issues so far, all good. I ordered another 8-pack for the Mini's and 18490 Woodvils, for backup (my wife has a mini and a 18490, I have a mini and 2 18490's). The big Woodvil would need a small amount of material removed to allow the 9ml Japanese bottle to sit flush IMO, so it has not been converted. Probably best done with a dremel.
The 9ml bottle from Vapage fits in a woodvil perfectly with no adjustments needed!
I would never trust myself taking a Dremel to my woodvil.
Have we done a round-up of which bottles are best and who sells them? I'm having trouble following where the people who have had good luck got theirs from and where the people who had leaks-a-plenty got theirs from. And they all looks so much alike that I couldn't figure it out from the photos.
Yes please! Could you guys be so kind as to post the link to the bottles that you have found to work the best!
I'll just have to find something else to buy from Amazon because I'm all the way at the bottom of the dark continent and shipping will be about a million time more than the bottle costs!
![]()
That link above is the ones I got for our mini's and 18490's. The other link posted earlier in the thread has 11 bottles, 4 x 6ml, 4 x 9ml and 3 x something bigger, they are a bit thicker and I have only tried the 9ml one in a Grand so far with very good results but I don't use the Grand as much as the others, so its not really tested much yet. I think where people might have trouble is drilling or making a clean hole in the cap, an 11/64" drill bit works well but be careful of your fingers when doing this, since the cap is so small it can be difficult to hold it, and drill it from the inside out. Another thing to be careful of is the quality is not the same high quality of a Reo so check that the cap seals properly on the bottle first (gently squeeze the bottle under water, at 1.5 times squonk pressure, and make sure there are no air bubbles). If it passes that test, any leaks can only be around the hole you will drill.
I'd sure appreciate that also. I got the red capped bottles but I have a bit of leaking going on. I have a Mini2.1. Someone mentioned that their experience with the blue capped bottles were better?
Help is certainly appreciated. Thank you.
So I found these for $1.5 at a Japanese store here. It's only 6ml but in trying to see if it's easier to squonk, i just put one in my LP grand...keeping my finger crossed and will watch closely to see if it'll leak...![]()
![]()
![]()
![]()