im glad i founf this thread. everyones so helpful here..
I just ordered a kayfun and I am kind of confused. Where can I get a filler bottle or tip to fill the kayfun?
LOVE THOSE SISSORS! Please tell em where you got them....
I have spheroids and kayfuns I do agree with some juices flavor is a little better with the spheroid I think that's to do with the small close chamber. I like both the same my top 2 rebuildables by far.Also try normal silica and or different wire.
If you decide to get rid of it hit me up i'd trade you one of my spheroids and some cash for it I have many always will!
It seems like a pressurization issue. Check all your seals and make sure that everything is fastened firmly.Strange issue here. When I use the fill valve, juice comes out the top. Happens when the tank isn't anywhere near full (it's happened with the tank less than half full, about half full, and nearly full). Amount of juice in the tank doesn't seem to matter. Any suggestions? Obviously I'm already holding the device upside down while filling. Thanks.
I hope it is not the case, but it is possible that it might be defective. That having been said, I would check that all seals are installed correctly and all parts are fastened tightly. Do not waste the juice, use water to see if the leaking issue goes away.I just picked up a new kayfun and i been leaking around town all day. I got home, i tried different methods and still leaking. I tried to fill up from the top and turn it upside down to screw the rest of the way and the liquid just leaks out the mouth end. And put it upside down to fill up from the hole and it still leaks from the mouth end. and when i put it upright it vapes fine but sometimes it will leak out the middle hole (air intake). I need helppppp
I just did a re-wrap with 3mm Eko. I just used it "straight," i.e., without the fold and I could barely fold the end in. That thing is fat, but it seems to be working great thus far.
This. 3 and 2mm seems to work best. Any size should work, but it seems easier to wrap the coil on a thicker Eko.Also what is the best type of wicking material to use? I'm pretty excited to try this thing and I would like to at least have the right wicking material.
Do you take it off the base prior to the flame treatment? I have seen people torching silica on the base, but there is a think plastic isolator there. I am afraid it might melt.You can use the turbo lighter. For example such as in the photo
![]()
The wick can catch fire, it's not scary. Just let it burn, being careful of course. Coke is formed inside the coil and on the wick. Therefore it is necessary to press the button Fire several times. If the smoke does not appear - then everything is fine.