SX350J V2 Question

[rice721]

So I seem to have a bug with my boxer 75W SX350J V2. Whenever I get into the menu (pressing the fire button 5x) and go to configure mode and leave it there, the mod seems to think the sensor is on so it keep cycling through the configurations 1-5 (sensor is turned off).

Is this normal? Do I need a firmware update?

Second problem, not sure if its an actual issue or if its normal with this chip. If say I set M1 to temperature mode in Joules and M4 to power mode in Watts, when I cycle through the configuration in the main screen, it stays in the predominant mode. Meaning if I have the mod set to M1 which is TC and then try to go into M4 it stays in TC mode (but in the menu M4 is set to Power mode) and vice versa. Is this normal?

 

[rice721]

Ok so I figured out the sensor problem, with each configuration (1-5) you have to manually go in there and turn off sensor for each and every one of them. Now thats fixed.

Still working on the 2nd one. If you cycle through M1-M5 on the main screen it stays in the predominant temp or wattage mode, depending on what your original Config was set at. I guess this is normal for this chip? Thats a bit of a hassle.

Also I noticed, this thing is very very power hungry. According to the on screen battery indicator I'm getting ALOT of battery sag in power or tc mode and I didn't even build that low. It is a boxer 75W 26650 battery. Battery is from boxer (I think its the black basen).