Dies, the Phoenix...no wicks, no filler, coil on the bottom, yes?
The mouthpiece is replaceable with a 510 DT? The tube itself made of poly or?
I know, I know. Read the specs on site...I will.
You've just got my curiosity piqued and looking for the short answers.
Darn i wish i would have read this before i took the second phoenix apart as i would have showed you detail pictures of the parts inside.
The tube is a some sort of plastic Pokey and one can squeeze it slightly if a lot of pressure is applied with fingers so not a hard type plastic.
Here is what i did and learned it from the video as i mistakenly put in some homemade juice that i messed up and started vaping.
Used syringe needle only to insert in fill hole and pry that silicone cap off and put aside, turned the phoenix upside down and taped it on my desk and metal machined tube falls out leaving the coil assembly connected to 510 connector intact and still in tube.
With glasses i observed down in tube the coil which has wick coming out each side that are very short, the coil had about 6 to 7 wraps. No filler at all like them cartomizers
To clean out any old liquid taste i fill with water and blow thru mouthpiece end bunch of times then shake like one shakes an old thermometer to read body temp.
I then dry tube with tissue.
Fire coil in short burst afterwards and it helps somewhat dry the wicks from the water just not completely.
Drop metal tube onto coil assembly and used only the needles other end the plastic end not the pointy needle and pushed the tube until it snapped in place.
Now with fingers i insert the cast aside silicone filler piece into tube and then using needles opposite end i push that down over the airtube as it fits over the center hole of airtube and little hole in silicone filler piece nice and snug.
I then filled as instructed the phoenix upside down and vaped and it vaped well as the first phoenix i been using from package.
Yes a normal 510 tip will fit the tube,as a note a small syringe , 2 needles, and a somewhat hard rubber normal looking rubber mouth piece comes in package .
I dont like rubber so i use my mouthpiece for it.
Here is video that i learned from cleaning the phoenix
http://www.e-cigarette-forum.com/fo...3ml-tank-version-bottom-coil-2-ohms-both.html
As a note Lord Davon seems to really like the phoenix while at this point i agree i still have to use them more till im completely satisfied thats just me.
The vision stone worked like a champ for 1 week for me then it started leaking at the bottom caps threads which was easily fixed with an arry spare o- ring but i could not stop the gurgling and leaking out the connector and also e-liquid coming into the top cap well and into my mouth.
So i just vape them more and learn from past experience .
Hope this helps give some idea's .
