the duke wood mod project

[carlph]

So i bridge on side of The 18650 holder kan a solder bothe The negativ and positiv wire on the otherside or have them both on one batt?

 

[carlph]

Done! there is some power in this one

 

[mxrdrver]

1x OKR-T10 regulator
2x 16v 10uf tantalum capacitors
1x 220ohm resistor
1x 15kohm resistor
1x 200ohm potentiometer
1x Push button of your choice
1x 2x18650 battery holder
1x 510 mod connector

You can get most of the stuff from digikey, except the 510 connector.

I just watched the how to video of the Duke by Goss. I didnt see him using any resistors in his build. Where would i put them and how would they help?


Sent from my iPhone using Tapatalk

 

[wigbill98]

They are under his heat shrink on the chip. I'm sure they are there. I used them on my okr build i just did.

Sent from my SM-G900V using Tapatalk

 

[e30Birdy]

Done! there is some power in this one

Which battery holder is that? got a link?

 

[carlph]

So i buildt another duke wired in The same way but dident fire untill i put The pot on highest setting.. And i dident get full power IT just sizzeled a little anyone now whats wrong?

 

[Visus]

Check the pot, maybe wrong ohms instead of 200 its 2-200k ohms.