And then the boasting really starts! 'yeah - gave it up - oh about a year now - no problem - a Reo and naff all willpower!'
You'll see, and congrats
T
You'll see, and congrats
T
The REO Lounge - Part III
- Thread starter redeyedancer
- Start date
- th_trl_thread_readers 0
- Status
i never did manage to save enough coupons for that Marlboro ski-jacket! it's my opinion that by the time i did - i'd be riddled with COPD and unable to ski anyway!
"hey guys - just put me on a sled and shove me down the hill - i have my cool ski-jacket on!"
"hey guys - just put me on a sled and shove me down the hill - i have my cool ski-jacket on!"
I'm about 1/2 hour away from the full 365 !
See my banner !
Congrats on your vaperversary!
Bob congrats on the year mark. I'm excited I've made it almost 4 months straight now so I can only imagine how good a year feels!
And SWMBO very nicely (or cruel depending how you see it) sent me this a little bit ago.
And SWMBO very nicely (or cruel depending how you see it) sent me this a little bit ago.
So I am going to go for a Grand, stepping into the world of mechanical mods 
I currently have an SVD with stacked AW IMR18350 700mah and at 15 watts that lasts me most of a day, Trying to figure between two 1600mah AW IMR18650s and replace them when they get to 3.0 or when the performance drops off, or the panny NCR18650PD 2900mah I do not plan on going lower than 0.8Ω so either will be more than enough drain wise. Any suggestions?
I currently have an SVD with stacked AW IMR18350 700mah and at 15 watts that lasts me most of a day, Trying to figure between two 1600mah AW IMR18650s and replace them when they get to 3.0 or when the performance drops off, or the panny NCR18650PD 2900mah I do not plan on going lower than 0.8Ω so either will be more than enough drain wise. Any suggestions?So I am going to go for a Grand, stepping into the world of mechanical mods
That's as low as I go as well. I would stick to the AW personally. But I use the 2000mah ones and two lasts me more then all day. Others will say different some of it is preference but the REO's were designed around AW batteries for fit.
Hi Aaron,
No...not yet. I'll try to take some time to watch that one this weekend....when I have some down time.
i don't really care what i whack in it! i have AWs, mnkes, orbtronics (rebadged pannies - those are good), and some samsung INRs. All fine - some better for sub-ohm.
What i do not use are protected AWs from my old (now a coil tester) Silver bullet because they crushed the spring and melted the firing button. My SB will swallow an 18700 battery - my Reo will not.
AW 18650 1600mAh are the recommended batteries and they are also highly rated for sub-ohm, able to handle a constant discharge of 24A (that allows you to make a 0.2Ω coil!! which your spring will not withstand.)
T
What i do not use are protected AWs from my old (now a coil tester) Silver bullet because they crushed the spring and melted the firing button. My SB will swallow an 18700 battery - my Reo will not.
AW 18650 1600mAh are the recommended batteries and they are also highly rated for sub-ohm, able to handle a constant discharge of 24A (that allows you to make a 0.2Ω coil!! which your spring will not withstand.)
T
Good evening everyone. Hope y'all had a great day. Good to see Norman pop in
Makes me want to send a copy of my banner to Phillip Morris,, with one of these
LOL made me laugh! VERY proud of you!
Good evening everyone. Hope y'all had a great day. Good to see Norman pop in
crap. you too?
hiya Scott! got the spelling accurate? sure?
But there are a load of new Reo guys and if they all think i am bad....
T
But there are a load of new Reo guys and if they all think i am bad....
T
- Status
Similar threads
