The Vmod XL 18650 Bottom Feeding Mod from Vapage.com
- Thread starter AlmightyGod
- Start date
- th_trl_thread_readers 0
- Status
To me, that was the biggest draw. I only use Mods that have 18650's. It's what kept me from ordering the original Vmod. Not a fan of having multiple kinds of batteries.
Actually, let me correct myself. My statement is not entirely true. I do have a pair of 3.0v Tenergy's that I use to kick a "slow" dual-coil's backside on my Silver Bullet every now and again.
But for me, 18650's rock!!
I have the entire stock of a battery store on my stand.
I don't have any of the 17000 series, but I have everything else covered.
And yes...18650's do rock!
I don't have any of the 17000 series, but I have everything else covered.
And yes...18650's do rock!
A quick Q:
How charged do the Vapage batteries come? I'm dying to try this out.
And, I'm gonna try the atty first, do I need to prime it from the top, like ordinary atties, or just let the bottle do it's job?
How charged do the Vapage batteries come? I'm dying to try this out.
And, I'm gonna try the atty first, do I need to prime it from the top, like ordinary atties, or just let the bottle do it's job?
Last edited:
I'm not sure how charged the batteries are...
The atty should be primed & allowed to sit for a few minutes. They are shipped without primer & take time to saturate properly.
The atty should be primed & allowed to sit for a few minutes. They are shipped without primer & take time to saturate properly.
I know they had some charge on them when I recieved mine, but just tested to make sure niether where DOA then put them on the charger, I was lucky in that I had a couple of batteries already to go.
Ok...ya got me..another damn battery!
Haven't heard of that one. Link?
sorry for the delay
http://www.xtarlight.com/en/05-chanpin/p-001-1.asp?styleid=149&style=Battery Series
finally got rid of the burnt taste on the 2.8 ohm cart w/ 5v vape by using a finger nail and place it between the silicon ring and the metal T pin and push it out.
Hey y'all,
I'm having connection problems with the atty and carto both. Do I need to adjust the center pins to make contact?
Or screw them in even tighter (trying not to force it)?
I'm having connection problems with the atty and carto both. Do I need to adjust the center pins to make contact?
Or screw them in even tighter (trying not to force it)?
Just got my shipping notice for the XL. Battery kit should arrive from Amazon around the same time. No tracking number from Vapage
Just got my shipping notice for the XL. Battery kit should arrive from Amazon around the same time. No tracking number from Vapage
don't worry its on its way never got also but shipping was fast
The threads on the XL are very tight on some of them.
Try lubing up the threads and screwing and unscrewing a few times.
You could also take the battery out, and clean the connection threads with some steel wool.
This should ease the tolerances and allow the atty to screw in properly.
Pulling out the pin will work too.
happen to me with 1 or 2 of my atties. they just needed to be pushed down a little further and tightened. i think the bottom lip of the atty's base was caught on the rubber seal. worked well afterward.
- Status
Similar threads
- Locked
- Locked
