Twisted 26g in subtank mini rba?

[cj081283]

Hey everyone, still a pretty amataur coil builder but I was wondering if anyone has any experience trying to get a twisted 26g into the mini v2 rba? For the life of me I cant get the wire to really trap down. Ive had no problems in rdas but this build deck seems to like to fight me lol.

Sent from my GT-N5110 using Tapatalk

 

[eddiea]

Hey everyone, still a pretty amataur coil builder but I was wondering if anyone has any experience trying to get a twisted 26g into the mini v2 rba? For the life of me I cant get the wire to really trap down. Ive had no problems in rdas but this build deck seems to like to fight me lol.

Sent from my GT-N5110 using Tapatalk

Try 6 wraps at the most for compressed/contact coils, or less wraps for spaced coils.

 

[TonyB66]

It's bordering on too thick. Try a single wire.

 

[cj081283]

I normally run a single while around a 3mm screwdriver and come out about 1.1 ohms and I enjoy it but I was just trying to play around with different builds in it to see if I'd like it more.

Sent from my GT-N5110 using Tapatalk

 

[eddiea]

As I mentioned previously, 6 wraps is fine but use a 2.5mm ID (because airflow will suffer if you go higher). Here's a twisted 26g Titanium 2.5mm build I did a couple of weeks ago...it performs well:

 

[cj081283]

As I mentioned previously, 6 wraps is fine but use a 2.5mm ID (because airflow will suffer if you go higher). Here's a twisted 26g Titanium 2.5mm build I did a couple of weeks ago...it performs well:

Thanks for the tips. I did either 4 or 5 wraps around a 2.4 mm screwdriver and I managed to get it situatated at .35 ohms. The flavor and vapor production are way better now...and juice consumption is way higher now. [emoji57]

Sent from my GT-N5110 using Tapatalk