USB Passthrough not working (KR808-1 to 510 atomizer)

[Mooler]

I have 2 KR808-1 USB PT without battery, and 2 kinds of adapters to 510, but no vape.

The same USB ports that powered my 510 PT (with batteries) wont power the KR808 or the adapters are not working? The ports are good, I can plug the mouse in there.

I also tried my portable car battery jumper USB port, no luck.

Is there a power issue? Wouldn't I get at least a little vape with too low power?

I wish I had an 808 atomizer so I could see if it's the adapters or the power source...

Also if you could recommend an AC USB adapter I'm probably going to order a couple.

Thanks

 

[Kent C]

I have 2 KR808-1 USB PT without battery, and 2 kinds of adapters to 510, but no vape.

The same USB ports that powered my 510 PT (with batteries) wont power the KR808 or the adapters are not working? The ports are good, I can plug the mouse in there.

I also tried my portable car battery jumper USB port, no luck.

Is there a power issue? Wouldn't I get at least a little vape with too low power?

I wish I had an 808 atomizer so I could see if it's the adapters or the power source...

Also if you could recommend an AC USB adapter I'm probably going to order a couple.

Thanks

It's in the amperage rating of the port. The KR808D-1 needs 1200miliamps and the 510 with the inline battery while does best on 1amp can be run on 500mA and most plugs/ports are rated 500mA - usually says so on the plug but if it doesn't then it may be 100-300mA.

V4L site has the correct plugs to run them and best running from a wall plug rather than the computer anyway.