VV batteries (ego twist)??????

Status
Not open for further replies.

Ruth-Ann

Senior Member
ECF Veteran
Feb 17, 2013
83
23
Ontario, Canada
Need help... I am a new to vaping and I am trying to get a good setup.
I have an Ego starter kit that came with 2 1100 non vv bats, and stardust clearomizers.
I already upgraded from my stardust tanks (they leaked), I now have iClear 16 duel coils (happy).

I am wondering if I should get a vv battery, but I have no idea what they do or how to use one.
Would using one give me more clouds??? Extend/shorten bat life??


HELP!!!
 

john333

Ultra Member
ECF Veteran
Verified Member
Mar 20, 2011
1,658
1,129
Indiana
the ego twist has three volt settings by simply twisting the bottom. the first setting is 3.7 which is what your current ego battery is. by switching the twist to a higher setting it will produce more vapor and possibly improve the flavor. also as your cart/atom gets used over time it will produce less vapor. with a twist you can turn up the volts and get more use from the cart/atom. also higher volts will drain the battery quicker but its well worth the increase in vapor. good luck
 

jcarax

Full Member
Feb 11, 2013
56
20
Tucson
It has more than three settings. It has labels at 3.2, 4.0, and 4.8. It also has tick marks every .2 volts inbetween. But, without testing output, it seems to be an analog dial.

I second a Vamo. Any Ego battery is ultimately disposable as the battery loses capacity, or the thing just falls apart. The nicest thing is they're fairly compact, and cheap.
 

bfitz

Senior Member
ECF Veteran
Feb 2, 2013
197
86
ohio
You can burn out a clearo if you turn it up to much, I believe the advice around here is the ohms of the clearo plus 2 for the voltage. For example, 2.0 ohm clearo could be set around 4 volts, plus or minus a bit to taste. I follow this rule on my twist and have been okay, hopefully some one much more electrically inclined than I am could explain further.
 

bilbobaggins30

Vapin' Hobbit
ECF Veteran
Feb 19, 2013
621
425
32
The Shire
You need to know the resistance on your clearomizer, and then use this chart to get your voltage (safe range):

unled66.jpg
 

DesmondTheMoonbear

Super Member
ECF Veteran
Dec 27, 2012
467
237
34
maryland
There are tons of charts out there showing what voltage you should use with which resistance head resulting in a certain wattage. They're all different, the best thing to do is start as low as possible and work your way up in small increments until you find your sweet spot. You'll know right off the bat if you've gone too far, because the taste will become terrible. I would also recommend the VAMO. Batteries become useless eventually, a twist costs twenty some odd dollars to replace. But an 18350 or 18650 battery that fits into your VAMO (or any mod you choose) cost no more than eight dollars or so. It's extremely cost effective) after the initial 40 dollars or so for the device. Also, if your run the VAMO (or another mod)with 18350 or 18650 batteries and have two, you can always have one in the device and one in the charger(similar to a charger used for rechargeable AA's, only larger). No wait time necessary to vape

Sent from the MOON, using Tapatalk MOON™
 

DesmondTheMoonbear

Super Member
ECF Veteran
Dec 27, 2012
467
237
34
maryland
Eight watts is a good starting point. So enter eight watts, the ohms of your atomizer, and try the voltage this calculator gives you. If you aren't getting much flavor, or it tastes harsh or burnt, turn it down. If it's too sweet or you aren't getting enough vapor, turn it up.

While i would usually agree with this, it's been shown time and time again that even with a variable wattage device( where when you set your wattage you should theoretically get the same vape out of any device regardless of the resistance) that different devices react differently regardless of their resistance. For example, i can run my 2.4 ohm vivi nova at 12 Watts and get excellent flavor. If i use the same wattage on my 2.4 ohm kanger t3 however, i get nothing but burned taste until i bump it down to about five watts. That's why imo it's better to just start at the lowest setting and work your way up.

Sent from the MOON, using Tapatalk MOON™
 

DesmondTheMoonbear

Super Member
ECF Veteran
Dec 27, 2012
467
237
34
maryland
A twist would definitely be a good starting point for getting into vv, but from my experience, you'll be looking to get into a nice mod within two weeks after getting your twist, so why not save yourself that extra twenty bucks to Get some great juice to use on your new mod? ;D

Sent from the MOON, using Tapatalk MOON™
 
Status
Not open for further replies.

Users who are viewing this thread