Hello,
So I got a Drop Dead yesterday & the 1st build I put in was double Clapton that was .17ish & nothing, no coils activating I don't remember if it said anything. I contacted the company, not sure if I should say who but very nice & if it was DOA they were gonna help. Went to make a video as they requested so I put coils I made nothing special just .23 build & it fired right up, I was so excited!! Earlier today it did say low atomizer & no idea what it means but I checked the leads & they were tight, & somehow got it working. I was sick if my generic coils so I grabbed 2 pre-made juggernauts that ohm out at .08 & what ya know, it says low atomizer again. Is it the coils & they're too low ohm for my RX 200? That's the only thing I can think of?! Plz help as I only have a limited time with this company to send back. I couldn't decide between this & the drop but If it's the coils that wouldn't matter! It's awesome when it works! I really hope it's user error.. No leads are touching, everything is tight one of the leads is touching the right of where it gets screwed in at but that shouldn't matter cuz all leads will be touching the front after the screw is in place & holding it down. Yes, I know the build isn't straight,& perfect but I was gonna fix when getting out hit spots so no hating lol! Please, please, please tell me what's going on w/ low atomizer. Ty everyone!
So I got a Drop Dead yesterday & the 1st build I put in was double Clapton that was .17ish & nothing, no coils activating I don't remember if it said anything. I contacted the company, not sure if I should say who but very nice & if it was DOA they were gonna help. Went to make a video as they requested so I put coils I made nothing special just .23 build & it fired right up, I was so excited!! Earlier today it did say low atomizer & no idea what it means but I checked the leads & they were tight, & somehow got it working. I was sick if my generic coils so I grabbed 2 pre-made juggernauts that ohm out at .08 & what ya know, it says low atomizer again. Is it the coils & they're too low ohm for my RX 200? That's the only thing I can think of?! Plz help as I only have a limited time with this company to send back. I couldn't decide between this & the drop but If it's the coils that wouldn't matter! It's awesome when it works! I really hope it's user error.. No leads are touching, everything is tight one of the leads is touching the right of where it gets screwed in at but that shouldn't matter cuz all leads will be touching the front after the screw is in place & holding it down. Yes, I know the build isn't straight,& perfect but I was gonna fix when getting out hit spots so no hating lol! Please, please, please tell me what's going on w/ low atomizer. Ty everyone!