I have not seen anyone else doing this thought I would toss it out to my friends to check out. I am assuming you have built wire mesh coils so I'll get right into this.
Build your mesh wick as usual but then cut another piece of mesh around 12mm x 40mm. This can vary depending on your genny I'm building a RSST here.
Then take the newly cut mesh and wrap around the top of the wick making it thicker.
I left the new top wrap un-torched so its easier to see whats happening. Torch yours.
Then insert into your genny and trim as needed. And coil as usual.
This gives me more ejuice directly under the coil. I'm liking it.
enjoy,
Wallace
Build your mesh wick as usual but then cut another piece of mesh around 12mm x 40mm. This can vary depending on your genny I'm building a RSST here.
Then take the newly cut mesh and wrap around the top of the wick making it thicker.
I left the new top wrap un-torched so its easier to see whats happening. Torch yours.
Then insert into your genny and trim as needed. And coil as usual.
This gives me more ejuice directly under the coil. I'm liking it.
enjoy,
Wallace
