Wires to Big!!!

[jayyco]

I made a custom wire for my rda that i really want to try out. It fits single coil but I use dual coils, so the two wires wont fit in the center negative post in the rda. Could i drill out the center post a little bigger? Or is there anything easier i can do??

 

[Botomline]

Put one through the post and the other at the screw.

 

[jayyco]

Put one through the post and the other at the screw.

Thanks!! But is there any other way so the coil wont be crooked?

 

[Botomline]

You can run dual coils with a single wire but it's tricky and takes practice. Use a single wire run through the center before you coil. Tighten down the center post then make a coil on each side and hook to the negatives. Not overly difficult but takes focus.

 

[cramptholomew]

I've seen people drill them out to 1/16". I've been on the verge if doing this to accommodate dual 24g coils in my chimbus. I need a better bit first.