WTAs and using .2 subOhm coil wattage question

[ZenCloud79]

I just got some VS DIY Unflavored WTA 24mg (100% VG) from aromaejuice.com
After making my purchase I saw they also offer a Sub Ohm Unflavored WTA Whole tobacco Alkaloid 6 MG. Its my first time buying and using a WTA for my DIY mixes. Can I still use the regular 24mg with my .2 subOhm coil? Or should I have gotten the 6mg sub version? Hope I didn't make a mistake cause that stuff is very expensive! If its ok what wattage is used for WTAs or does it matter? Thanks in advance.

 

[madstabber]

It depends on what mg of nicotine you currently use. Being that you got a higher mg you can always dilute it so you haven’t wasted your money. I used to use a 2.4-1.8 ohm coil and 36mg of nicotine. When I switched to subohm coils I reduced my nicotine to 20 mg because I was getting nauseous from too much nicotine. If you use 24mg’s with coils above 1ohm I’d try it with your .2 coil and see if it’s too much. If it is you can dilute it with flavoring or PG/VG to a more desirable mg. Good luck to you

 

[ZenCloud79]

I make 6mg batchs. Good to know I can still use it and dilute it. Is there a best wattage for wta?

 

[madstabber]

I make 6mg batchs. Good to know I can still use it and dilute it. Is there a best wattage for wta?

It’s no different from any other juice. I’d try whatever wattage the coil recommends. Begin at the low end and work your way up until you find a wattage you enjoy.

 

[ZenCloud79]

Ok thanks