About the Vision Deux...

[X-Factor]

I had been using the Maximizer for a while and it produced great vapor and had great flavor too, now I ordered the Vision Deux because I no longer see the Maximizer at the Gotvapes website (Is it no longer available fron Gotvapes???), anyway, this Vision Deux does not produce enough vapor, dry hits and is extremely harsh on my throat with little to no flavor. Granted it is my first try at these, but so far it is going aweful for me at least.

 

[ZebadeeDoodah]

Here's badkolo's response to another person with the same problem:

what you can do just in case during production the inner plug was pressed in, you can take a tool or tweezers or small eyeglass screwdriver, and gently lift the inner plug so that the slots thats are cut out on the inner plug on both sides is lifted a little so you can see more of the slit in the cup, the replace your mouth peace and vape. this will alleviate any closure that the inner plug may have caused allowing juice to get in and do its job, other then that these are simple as you get.

 

[badkolo]

they are 3.0 ohm, 3.7 and 4.2 should produce good vapor, let the juice soak for 1 minute, and take slow long drags

 

[zer0ith]

Another thing I will add is that they get soooooo much better over time. Anywhere from 1/2 a tank to a full tank and they really come to life (from brand new, after cleaning they still rock).

 

[badkolo]

all visions need a small break in period, just keep vaping it, its not meant for 3.2 volts, so use it above that, this wont be a issue soon as the new ones being produced are 2.6 to 2.8 and not 3.0 to 3.1 with vary few coming in at 2.9 but this has been addressed so people with 3.2 can enjoy it as well.

also if you feel no juice is getting to the coil then lift it up a tad and that should do the trick

 

[X-Factor]

Thanks everyone, I did try lifting the inner seal once already on my own, thinking by myself that it could be the problem, but it didn't work (think I barely moved it the first time), so after your suggestions I tried it again, and this time I pulled it all the way out, then reinsrted it so it was a little above the original place, and it seems to be working a lot better now - good vapor, better flavor and no harshness anymore. It's working like the Maximizer did (without all the leaks of the Maximizer, or the loose mouth-peice of the Maximizer, lol)

Thanks for urging me on with the idea to go back and lift it again. It was either that, that cured it, or it went through the "break-in" that you guys mentioned. Either way, thanks.