Hey guys, I just started vaping again after a few years away... and boy has the equipment improved over the years. Question I have the T3 Clearomizer and would like to know the best way to clean these and the atomizer? I want to try different flavors and obviously want to make sure that I am not getting flavor from the previous juice.
Best way to clean my Smokeless Image products?
- Thread starter osmo
- Start date
- th_trl_thread_readers 0
- Status
Theoretically, you can take them apart. I've never tried as I've also heard it's difficult to make them work properly again. This may or may not be true, I don't know.
To clean, I fill a syringe with water, inject it in with the clearto right side up (needle pointing down) and push the water through. It leaks, as it's supposed to when filled like that, running the water through.
Blow out, let dry, and use. The first dozen or so puffs might be really watery/airy until the juice gets back down the wick.
To clean, I fill a syringe with water, inject it in with the clearto right side up (needle pointing down) and push the water through. It leaks, as it's supposed to when filled like that, running the water through.
Blow out, let dry, and use. The first dozen or so puffs might be really watery/airy until the juice gets back down the wick.
Welcome back to SI!
There is another SI thread that has quite a lot of information about the SI T3. It contains questions and answers about care and cleaning of the T3's also. You will find great help there.
http://www.e-cigarette-forum.com/forum/smokeless-image/362281-tried-t3-si-yet-thoughts.html
2009. I guess so
welcome back!Edit Just went to that other thread, 12 pages! Basically just rinse under the tap. Just be careful because there are a couple of thin wicks on top of the regular wicks that are easy to dislodge.
Edit #2 The air tube just wiggles off, after you've unscrewed the base of course. Again, be aware of the two small wicks mentioned above.
Last edited:
- Status
Similar threads
