just got a IBtanked tank and got some boge cartos SR. not getting the vapor production id like to. i made the holes a little bigger.. when i take off my drip tip the top of the polyfiller isnt wet im not sure why im not getting big hits?
-
Need help from former MFS (MyFreedomSmokes) customers
Has any found a supplier or company that has tobacco e-juice like or very similar to MFS Turbosmog, Tall Paul, or Red Luck?
View thread
Cartotank help
- Thread starter danwicklund
- Start date
- th_trl_thread_readers 0
- Status
its standard resistance whatever that is probably around 3ohm ya...can only go up to 4.8 on my twist, i just orederd the provari yesterday so i will wait for it to get here and try it with more volts to see if that helps..still dont know why the pollyfill looks dry when i remove my drip tip...im not getting dry hits just not as much vapor as id like...i take prime puffs watch the air bubbles come up but ya...hmmm
did you get the boge with big hole in it from smoktech or where? i did also order a punch so i will be punching my own just wondering where those big hole pre punched cartos come from
I don't use cartos but I've heard put a few primer drops into the polyfill. Also at 3 ohms you'll barely get any vapor from 4.8V just because it'll take it forevverrr to heat up the coil. You'll have to get lower ohms, or yeah just wait for your provari and blast it with 6ish volts.
Doesn't need to be wet on top. Mine have always run dry there. If it was wet, it's probably flooding and Then there would be little vapor because it overwhelms the coil.
I find cartos have a Much better taste and hit in a carto-tank than not- just because of it Not being totally full.
I find cartos have a Much better taste and hit in a carto-tank than not- just because of it Not being totally full.
You are saturating the carto before putting it in the tank, correct? I really hate it when you get a new toy and it doesn't work the way you hoped it would.
- Status
Similar threads
