OMG! I just busted the positive pins on both of my new 24mm Sirens!
After busting the first one, I assumed it was a goner, put it aside and requested an RMA from Eciggity. Opened up my second one to build, gently tightened the pin, and snap!
Upon closer examination, it appears these come in two parts, and I was able to unscrew and remove the remaining piece. I think the proper way to tighten these might be to remove the outer piece first, tighten the inner piece, then very gently screw in the outer piece.
It doesn't look like Eciggity sells replacement pins, but I canceled the RMA and ordered some new pins directly from geekvape. Glad there's a fix, but bummed, 'cause I was really diggin' this tank.
After busting the first one, I assumed it was a goner, put it aside and requested an RMA from Eciggity. Opened up my second one to build, gently tightened the pin, and snap!
Upon closer examination, it appears these come in two parts, and I was able to unscrew and remove the remaining piece. I think the proper way to tighten these might be to remove the outer piece first, tighten the inner piece, then very gently screw in the outer piece.
It doesn't look like Eciggity sells replacement pins, but I canceled the RMA and ordered some new pins directly from geekvape. Glad there's a fix, but bummed, 'cause I was really diggin' this tank.