The complete tanks comes with a refilling drip tip we have been discussing above and a cartomizer so it is ready to use. Lube the orings with a qtip and insert the cartomizer with the refilling tool on it. Make sure you back up the cap away from the end you are pushing from when either inserting the carto or lowering for filling.
I would do a practice run on putting the carto in and lowering then reseating it so you are familiar before filling, seems a few folks have had to wipe up their elbow as part of the lesson plan
Fill the carto by squeezing the liquid in the gap between the drip tip and cap while the carto is lowered then slide the carto up into place and remove the refilling tip. Now drop the full tank into the thingy and put the lid on, you will see some air bubbles, remove the lid and replace it 10 to 20 times until about a quarter of the tank is gone. Now with it on the battery use short button presses while drawing to make sure the coil is wet, when you taste the flavor and are getting vapor you will know. Use some longer presses on the power button a few more times to really get it going good then vape away.
Getting the carto primed and started out correctly is critical. You dont want to burn it from no liquid on the coil, once its wet and as long as it stays wet it should last a week or two and all you have to do is keep filling the tank up when it gets low.
Sorry but we are about out of cartos so I dont have them available other than for with the complete tanks until we get more in. I usually send folks to Hoosier ecig supply when we are out, they dont carry the exect same ones we use but you can get a 3ohm two hole there. Hopefully we will be getting our cartos in soon. We had one shipment that ended up being the wrong ones and are trying to sort that out now, we really liked these though so certainly we want to get more of them.
OH MY.. this is already scary. Pfft... I'll figure it out or burn it up, I guess. I'll order extra cartos from somewhere just in case!
OK.. printed the lesson. Lube the orings w/ what?
As to ohms... 2.0 or 3.0 w/ a 3.7V battery? And 1 or 2 holes punched?
I was not kidding when I said I do NOT know what I'm doing. But I DO KNOW that I'm not going to figure it out unless I punt and buy something and give it a go.
Last edited:
