Hangar--I do not think I have tried the M201, so I can not compare it. Where did you get it and I may give it a go---Sun
DSE801 "Penstyle" Review after 2 months
- Thread starter JeremyJames
- Start date
- th_trl_thread_readers 0
- Status
Hangar--I do not think I have tried the M201, so I can not compare it. Where did you get it and I may give it a go---Sun
Strictly in terms of vaping, the m201 is the perfect pen for me - draw, timing and heat are just right.
But ... it's totally incompatible with any other pen, it has the extra, double-super sensitive switch so it goes off all the time (like in your pants in the car, if you sneeze etc.) and the carts are an extremely tight fit, so much so that I have to twist to remove and that's not good.
I reserve it for my high nic juice so it doesn't get used as much.
But ... it's totally incompatible with any other pen, it has the extra, double-super sensitive switch so it goes off all the time (like in your pants in the car, if you sneeze etc.) and the carts are an extremely tight fit, so much so that I have to twist to remove and that's not good.
I reserve it for my high nic juice so it doesn't get used as much.
fjames....You could do the following....remove the LED cap....right under it is a chip...If you blow on it the chip the LED will light up....on this chip there are two tiny holes......you can put a small tape or with a hot glue cover the holes. This will make your batteries less sensitive but not effect your vaping.
Okay, I'm totally befuddled by this. The tape didn't work, if blowing across the battery to light the LED is a valid test. It didn't effect the response of the LED at all. Oh, btw, one of the two batteries I used had only one open hole - the other one was in use/plugged.
I carefully inspected the cap and LED end of the battery for any source for air passage with a small powerful light and saw none. Even so, I taped up the outside of the battery LED end good and tight but it didn't have any effect either.
Thanks to your second post I got the idea to lightly lay a piece of kitchen plastic wrap over the exposed end of the battery, then push the cap back gently, thus drawing the plastic wrap into the battery tube.
This worked perfectly. Draws like stock, LED lights, but when blowing across it outside the tube, no light at all. I'll have to further test with a drive in my noisy, rough car. If anyone wants to try this, so far I've found the best way to remove excess wrap is to hold the cap with a finger for stability, the battery tube vertically, and pull straight down with a finger nail, thus using the end of the battery tube as a cutting edge.
I wish I knew why this worked lol. Thanks again.
I carefully inspected the cap and LED end of the battery for any source for air passage with a small powerful light and saw none. Even so, I taped up the outside of the battery LED end good and tight but it didn't have any effect either.
Thanks to your second post I got the idea to lightly lay a piece of kitchen plastic wrap over the exposed end of the battery, then push the cap back gently, thus drawing the plastic wrap into the battery tube.
This worked perfectly. Draws like stock, LED lights, but when blowing across it outside the tube, no light at all. I'll have to further test with a drive in my noisy, rough car. If anyone wants to try this, so far I've found the best way to remove excess wrap is to hold the cap with a finger for stability, the battery tube vertically, and pull straight down with a finger nail, thus using the end of the battery tube as a cutting edge.
I wish I knew why this worked lol. Thanks again.
i dont own one Sun...just shopping around is all and trying to learn as much as possible.
Fjames I tried your idea and it seems to work pretty good...made the draw a tiny bit harder but if it stops it from going on from wind and car noise than it is great ...since it would be easier to do than using a glue gun and certainly prettier than having a condom on the end of your ecig.
BTW I have no idea why it works.
I'm awaiting my BE112 from Bestecig as we speak, and I only have 1 piece of advice for you: get liquid over carts, anyday. Dripping on the atomizer provides better vapor, flavor, and throat hit, and liquid flavors beat the hell out of cart flavors any day, and they're also less expensive. Just my experience =]
I also have BE12, it's kinda hard to drip on a 801 atomizer and I don't want to mess it up or mess up the battery...
Do you mean refil the carts? There are loads of vids on here and youtube. Spikey's is a great place to start http://www.e-cigarette-forum.com/fo...2-new-updated-comprehensive-intro-vaping.html
Lee.
Edit Another awesome thread to check out... http://www.e-cigarette-forum.com/forum/new-members-forum/2562-helpful-links-videos-new-user.html
You can find loads of helpful stuff in this part of the forum http://www.e-cigarette-forum.com/forum/new-members-forum/
Last edited:
Hi guys, I have received my DSE801 from HeavenGifts and it is a great device. I've never had that much smoke and throat hit from any device up to now. Something I noticed is the filling of the carts get pushed back in by the atomizer and soon not enough liquid is licking inside. Any suggestions how to fix that?
hopllit, I think you have one of the new atomizers, with a higher coil, there haven't been many reports on it.
Just got my 801 from Heaven ... From Heaven Gifts, actually. Not directly from a divine location.
Anyway, 1st I was surprised at the size. Is big, yes?
2nd - it's really set up different and took me a moment to figure out. I'm used to the 401.
3rd - way more vapor but less of a throat hit. Could be the prefilled cart, once I suck it dry I'll try with some Truesmoker Blackberry.
4th - I think I'll clean up the ol' 401 and give it to my sister to get her hooked. If she and my mother would reduce their analog usage, maybe my youngest son would visit them more often (even as a pack-a-day smoker I could hardly stand my mothers house)
I think ol' Ruyan sent me the wrong color, but I guess I don't really care all that much.
Anyway, 1st I was surprised at the size. Is big, yes?
2nd - it's really set up different and took me a moment to figure out. I'm used to the 401.
3rd - way more vapor but less of a throat hit. Could be the prefilled cart, once I suck it dry I'll try with some Truesmoker Blackberry.
4th - I think I'll clean up the ol' 401 and give it to my sister to get her hooked. If she and my mother would reduce their analog usage, maybe my youngest son would visit them more often (even as a pack-a-day smoker I could hardly stand my mothers house)
I think ol' Ruyan sent me the wrong color, but I guess I don't really care all that much.
So thank you for all the info. If I were to order this one right now, what is in the cartridges. What flavor, strength and so on. I am ready to do this but after much reading still a lil lost.
So thank you for all the info. If I were to order this one right now, what is in the cartridges. What flavor, strength and so on. I am ready to do this but after much reading still a lil lost.
Try watching this video...
http://www.e-cigarette-forum.com/fo...2-new-updated-comprehensive-intro-vaping.html
The carts are usually 1 or 2 in "high" strength (but what is "high" varies by company). 1 or 2 medium, one low and one zero nic (which will say "NO" on it... but it looks like "ON" if you look at it upside down lol! They are usually "general tobacco" unless it is Janty.. then I think RY4 is their standard? Someone correct me if I am wrong.
Thank you Spikey. Hot photos!
Do not have flash player or whatever, I am at work and cat watch it now.
Looking at the site to order the 910 it does not have the cartridges. Where do you get the cartridges that fit it and have a choice in flavors?
Do not have flash player or whatever, I am at work and cat watch it now.
Looking at the site to order the 910 it does not have the cartridges. Where do you get the cartridges that fit it and have a choice in flavors?
- Status
Similar threads
