I got this vape juice (OPULENCE - REAL MONEY) and was going to try it out in my new vape pen (Aspire PockeX) All of my other juices are 70vg/35pg or 65vg/35pg and not too thick so I use a 1.2 ohm coil for MTL vaping. When I started filling my tank the juice was super thick... it mounded up like thick syrup so I stopped. I also tried to prime the coil (0.6 ohm) through the top hole and the juice wouldn't even go down the hole, so I added some 65vg/35pg to the tank and top hole. I have not tried it yet. The label listed ingredients but could not read (even with magnifying glass) so I looked online and it shows 70vg/30pg. Did I get a bad batch? It says on the side of label "Mod Vape"... does this mean it's mostly vg? Should I just add some water to thin it out? I hope my 0.6 ohm coil will do fine... all my extra coils are 1.2 ohm. Does the juice separate (vg and pg)? Good thing I ordered some tobacco juice that's 50vg/50pg (18mg nicotine... I use it to boost my 6 mg juices... call it "crack-bac") so I can mix and should be OK, but still waiting for it.