[EDITED]

Status
Not open for further replies.

MFToms59

Ultra Member
ECF Veteran
Verified Member
Mar 19, 2012
1,547
3,842
Nevada
My spring sag I think was just from the spring breaking in a little. I never run under .6 ohms on the Phid. Also I stopped doing dry burns on it as well because that could have been a contributing factor.

I had a spring collape dry burning on a different mod, now I use my Regulated mod for that purpose.


I'm just shooting for a warm, dense vape with a fairly quick coil heat-up. I just tried the doge (which is not suited for that at all) since it was the only one I had laying around not being used. I'm going to try a higher build on my Odin bf and see if I can find the sweet spot. I know my spring sag came from waaaaayyy too low ohms, and that is totally my fault. I'd love to replace the spring on my own if possible. It's not Fono's problem that I decided to push the envelope

If you're using Synthetic flavored juices, contact coils of.9-1.2 ohms, with an inner diameter of ~1.6mm, will concentrate the heat & give you a warmer vapor. If you vape Naturally Extracted Tobacco/ NET juices, the coil will gunk ~4-7mls, depending on the juice, and will need to be dry burned more frequently.

The density of your vapor can be increased by using a higher VG juice.
 

unsure

ECF Guru
ECF Veteran
Verified Member
Feb 6, 2010
19,529
41,435
75
Silicon Valley, California
I'm always hear lurking in the shadows :p

lurker.gif
 

mommabird62

squonkhead
Supporting Member
ECF Veteran
Verified Member
May 11, 2014
7,247
30,462
63
NC
Hi all :) Brand new to the Phidias squonker and have one incoming from the classifieds. I am used to REOs (which I absolutely love!) so be gentle. ;) Have been reading older posts on using them and I am not quite understanding the fill method for the bottle. Is there a video that some one can point me to? Thanks!


Sent from my iPhone using Tapatalk with my paws :)

Mommabird62
 
Status
Not open for further replies.

Users who are viewing this thread