Eleaf Istick

Status
Not open for further replies.

op22222

Senior Member
ECF Veteran
Verified Member
May 11, 2013
266
386
South Western, PA USA
$15.50 including shipping. Not too bad. The options were a bit overwhelming, so I just went for black carbon fiber hoping for some grip. But for those wanting more for looks, there are plenty of choices. Looks like you have to find the print you want first, and then see if it's available for the istick. Or at least that's the only way I figured it out.

And yes Flt, I'm quite happy with my baby. You'll note the nauty mini on it; I wouldn't even know what to do with more power. I'm a happy camper.

Many Thanks.
 

Big Screen D

Ultra Member
ECF Veteran
Verified Member
Aug 5, 2011
2,292
2,830
Georgia
Hey BSD. Thanks for your thread. It's what helped me hone my vertical builds in my KPT2s. Can you compare the Aspire BVCs to the vertical-hollow-core rebuilds?

I actually think that the factory heads are a little better. I'm pleased as punch with the consistency, flavor, and wicking.

The aspire coils last long enough for me that I don't mind spending a couple of bucks to change em out when needed.
 

aldenf

Ultra Member
ECF Veteran
Verified Member
Jun 26, 2014
2,558
10,293
NYC, NJ, USA
I actually think that the factory heads are a little better. I'm pleased as punch with the consistency, flavor, and wicking.

The aspire coils last long enough for me that I don't mind spending a couple of bucks to change em out when needed.

Hmmm... Looks like I'm in the market for an Aspire BVC tank. The Nautiluses are the only ones with AFC, correct?
 

Flt Simulation

Ultra Member
ECF Veteran
Jan 26, 2014
2,509
2,472
Florida
Thespis ....

Well, I have not read every post in this very long thread ... All I am saying is that any variable volt / watt battery should be able to not only increase voltage above what it's internal battery is charged at, but also decrease voltage too, if needed.

Some folks here use a fairly low ohm coil that requires a lower input voltage than a higher ohm coil in order to operate at the same watts of power ... but for some reason, the company that makes the iStick just don't make it possible to decrease voltage below what it's internal battery is actually charged at.


Just don't make much sense to me ..... Maybe you understand this much better than I do ?

All I am asking is for a regulated mod that is capable of not only increasing voltage (above it's internal battery voltage), but also decreasing voltage if so required by the user.

Is that asking too much?
_____________________________________

Even my cheap iTaste MVP 2 is capable of doing that ... and does it pretty well
 
Last edited:

lvm111

Super Member
ECF Veteran
Verified Member
Aug 20, 2013
663
916
Wylie, Texas
Now it doesn't jump say from 1-2.6 but it does go from 2.3 to 2.5. So say I look at it before puffing and it says 2.3. I take a puff and look down and it says 2.5.


Sent from my iPhone using Tapatalk

So don't look down. Just puff and enjoy!

best regards, larry mac
 

Ryan Lee

Senior Member
ECF Veteran
Jan 9, 2014
172
241
Kansas
www.youtube.com
Thespis ....

Well, I have not read every post in this very long thread ... All I am saying is that any variable volt / watt battery should be able to not only increase voltage above what it's internal battery is charged at, but also decrease voltage too, if needed.

Some folks here use a fairly low ohm coil that requires a lower input voltage than a higher ohm coil in order to operate at the same watts of power ... but for some reason, the company that makes the iStick just don't make it possible to decrease voltage below what it's internal battery is actually charged at.


Just don't make much sense to me ..... Maybe you understand this much better than I do ?

All I am asking is for a regulated mod that is capable of not only increasing voltage (above it's internal battery voltage), but also decreasing voltage if so required by the user.

Is that asking too much?
_____________________________________

Even my cheap iTaste MVP 2 is capable of doing that ... and does it pretty well

The iSticks pros FAR outweigh the cons. Their are plenty of other devices that step down out there if you so choose, and they are also a lot more expensive.
For 35 bucks, and for what this tiny little beast does, I don't think their is much room to disprove of it.
At least it is not underpowered, than we would never hear the end of it.
My MVP2 is retired as it couldn't push anything I had near a satisfying vape. Even a 1.8 bvc head on the Nautilus was weak on it at "11" watts. Felt more like 5.
 

KTMRider

Vaping Master
ECF Veteran
Verified Member
Jul 5, 2014
4,538
18,079
NJ
Many Thanks.

Ebay has a few for $6.49 shipped.


Thespis ....

Well, I have not read every post in this very long thread ... All I am saying is that any variable volt / watt battery should be able to not only increase voltage above what it's internal battery is charged at, but also decrease voltage too, if needed.

Some folks here use a fairly low ohm coil that requires a lower input voltage than a higher ohm coil in order to operate at the same watts of power ... but for some reason, the company that makes the iStick just don't make it possible to decrease voltage below what it's internal battery is actually charged at.


Just don't make much sense to me ..... Maybe you understand this much better than I do ?

All I am asking is for a regulated mod that is capable of not only increasing voltage (above it's internal battery voltage), but also decreasing voltage if so required by the user.

Is that asking too much?
_____________________________________

Even my cheap iTaste MVP 2 is capable of doing that ... and does it pretty well

The DNA 20 and 30 doesn't regulate down either. The DNA 40 does. Just pick one of those up. They start at $190.
 

aldenf

Ultra Member
ECF Veteran
Verified Member
Jun 26, 2014
2,558
10,293
NYC, NJ, USA
Thespis ....

Well, I have not read every post in this very long thread ... All I am saying is that any variable volt / watt battery should be able to not only increase voltage above what it's internal battery is charged at, but also decrease voltage too, if needed.

Some folks here use a fairly low ohm coil that requires a lower input voltage than a higher ohm coil in order to operate at the same watts of power ... but for some reason, the company that makes the iStick just don't make it possible to decrease voltage below what it's internal battery is actually charged at.


Just don't make much sense to me ..... Maybe you understand this much better than I do ?

All I am asking is for a regulated mod that is capable of not only increasing voltage (above it's internal battery voltage), but also decreasing voltage if so required by the user.

Is that asking too much?
_____________________________________

Even my cheap iTaste MVP 2 is capable of doing that ... and does it pretty well

Hey Flt Simulation. If you go back a few hundred pages, you'll see I was accused of beating the same dead horse. If you cared to read the thread, you'd learn that the iStick DOES regulate below native battery voltage. The WAY it regulates, however, prevents it from firing below an effective 4.2V. Read the thread or watch Phil Busardo's video. All is explained.

While, academically, many agree with you 100%, it appears that most are immensely enjoying the iStick with all of its engineering flaws. Look at the iStick as a smaller, much cheaper VaporShark DNA 20 that lasts an entire day on a single charge. Because that's about what it is. And I, for one, am loving it...

Cheers!
 

Katya

ECF Guru
Supporting Member
ECF Veteran
Verified Member
Feb 23, 2010
34,804
120,147
SoCal
The DNA 20 and 30 doesn't regulate down either.

True, but they state so clearly on their specs sheet. So people who buy them know (or, at least should know) what to expect from the device they are buying.

http://www.evolvapor.com/datasheet/dna30.pdf

Output Power: 7 Watt--30 Watts
Output Voltage: 4 Volts--8.3 Volts

OTOH, Joyetech released a video, 2 weeks ago or so, of some guy with a multimeter insisting that iStick's 3 volts is indeed 3 volts. That was truly embarrassing.

That's why I have a problem with Eleaf iStick--that they are trying to deceive people, not that their device doesn't down-regulate. Just tell me the truth.

BTW, Joyetech (and Janty) also insisted for years that eGo batteries output 3.7v. It was Scottbee who finally put the eGo (and the 510 batteries) on the scope and proved what we all had suspected for years--that eGo batteries are regulated at 3.2 or 3.3v and were never capable of outputting 3.7v under load. It still took Janty (and Joyetech) years to finally officially admit it and correct their specifications.
 
Last edited:

aldenf

Ultra Member
ECF Veteran
Verified Member
Jun 26, 2014
2,558
10,293
NYC, NJ, USA
True, but they state so clearly on their specs sheet. So people who buy them know (or, at least should know) what to expect from the device they are buying.

http://www.evolvapor.com/datasheet/dna30.pdf



OTOH, Joyetech released a video, 2 weeks ago or so, of some guy with a multimeter insisting that iStick's 3 volts is indeed 3 volts. That was truly embarrassing.

That's why I have a problem with Eleaf iStick--that they are trying to deceive people, not that their device doesn't down-regulate. Just tell me the truth.

BTW, Joyetech (and Janty) also insisted for years that eGo batteries output 3.7v. It was Scottbee who finally put the eGo (and the 510 batteries) on the scope and proved what we all had suspected for years--that eGo batteries are regulated at 3.2 or 3.3v and were never capable of outputting 3.7v under load. It still took Janty (and Joyetech) years to finally officially admit it and correct their specifications.

Katya, I think your point is what bothers me the most. We're not talking about a $10,000 used car that I'd HAVE to test drive first. The iStick is what it is and, fortunately, I'm enjoying it. I should, however, be able to purchase a $35 device based on published specs and have a reasonable idea of what I am getting. I shouldn't have to wait for vaping gurus to review the product and confirm the manufacturer is telling me the truth. The video you speak of, where the poor intern is hung out to dry, is sad indeed. The fact that Eleaf/Joyetech have yet to even acknowledge the discrepancy leaves me with little faith in either company. I will think hard before I purchase another product from them. But, for $35, it's the bangin' schnizzle! I guess when money talks, principles fly out the window...
 

Katya

ECF Guru
Supporting Member
ECF Veteran
Verified Member
Feb 23, 2010
34,804
120,147
SoCal
Katya, I think your point is what bothers me the most. We're not talking about a $10,000 used car that I'd HAVE to test drive first. The iStick is what it is and, fortunately, I'm enjoying it. I should, however, be able to purchase a $35 device based on published specs and have a reasonable idea of what I am getting. I shouldn't have to wait for vaping gurus to review the product and confirm the manufacturer is telling me the truth. The video you speak of, where the poor intern is hung out to dry, is sad indeed. The fact that Eleaf/Joyetech have yet to even acknowledge the discrepancy leaves me with little faith in either company. I will think hard before I purchase another product from them. But, for $35, it's the bangin' schnizzle! I guess when money talks, principles fly out the window...

Amen.

Just tell me that it's a "DNA-style" ;) device with following specs. Period.

Besides, it's so stooooooopid... :facepalm:
 

Kent C

ECF Guru
ECF Veteran
Verified Member
Jun 12, 2009
26,547
60,051
NW Ohio US
BTW, Joyetech (and Janty) also insisted for years that eGo batteries output 3.7v. It was Scottbee who finally put the eGo (and the 510 batteries) on the scope and proved what we all had suspected for years--that eGo batteries are regulated at 3.2 or 3.3v and were never capable of outputting 3.7v under load. It still took Janty (and Joyetech) years to finally officially admit it and correct their specifications.

"insisted"? hmmm.
 

Katdarling

I'm still here on ECF... sort of. ;)
Supporting Member
ECF Veteran
Verified Member
Jan 25, 2011
32,582
167,752
Utopia
Someone posted a Pre-Order for an IPV Mini Pre-Order for a Hundred and a Half.

Here is another Pre-Order I came Across.

IPV Mini Pre Order

This is Probably $20 ~ $25 more than the Final Price will be. But Much More Realistic than that $150 one.

WARNING: I know ABSOLUTELY Nothing about this Company. And am Not Making Any Recommendation that they are Reputable. Don't send me Hate Mail if you get into this Pre-Order and things go South on you. Or if the IPV Mini turns out to be a Ginormous POS.


That estimated shipping date..... does that fall on a Monday? :facepalm:



They are out of red iSticks. I know. I looked last night. Rock Bottom is out too. I'm sure you'll get your stick soon!

Just don't tell Kat that I've been looking--I don't want her to know. :facepalm:

Peer pressure... ;)


Your secret is safe, oh masked tweet one. ;)
 
Status
Not open for further replies.

Users who are viewing this thread