If you can do surface mount soldering, I'd just replace the BMIC. As I'm 95% sure that is the problem.
I'll be doing good if I can just get the 4 pads and balance connector soldered.If you can do surface mount soldering, I'd just replace the BMIC. As I'm 95% sure that is the problem.
On this DNA250 that I'm having problem's with I thought I'd open it up and charge it to find out if the heat was coming from the battery. It is not. The heat is coming off the two large inductors. I guess I'll put in a new board then attempt to RMA it.
I'm hoping that they think I'm "special"........but highly doubt it. Most likely they don't even know of my involvement .You should consider your self Lucky! I had a DNA75 burn up like that & it took out the whole mod with it! You just need a new board
RMA's are getting harder to get from Evolv these Days, Good Luck with that!
You should consider your self Lucky! I had a DNA75 burn up like that & it took out the whole mod with it! You just need a new board![]()
No, it was an 18650 mod,(Charged Externally) those 2 big things IDK what they are? They burned up & melted my modDid it overheat while charging?
No, it was an 18650 mod,(Charged Externally) those 2 big things IDK what they are? They burned up & melted my modThe burnt plastic smell was so bad that the whole mod was Toast!
![]()
Over yonder, "E", has been down for a few hours. Even the Alpha site is down.
Their commercial site is still operational.
Did you get a reply?E-mailed to Mr. B....