Evolv-ing Thread

[BillW50]

If you can do surface mount soldering, I'd just replace the BMIC. As I'm 95% sure that is the problem.

 

[tiburonfirst]

my flashlight replacement parts came today. and just in time - the moment i unscrewed the end cap to put the new one on it fell apart completely

 

[dwcraig1]

If you can do surface mount soldering, I'd just replace the BMIC. As I'm 95% sure that is the problem.

I'll be doing good if I can just get the 4 pads and balance connector soldered.

 

[Steamer861]

On this DNA250 that I'm having problem's with I thought I'd open it up and charge it to find out if the heat was coming from the battery. It is not. The heat is coming off the two large inductors. I guess I'll put in a new board then attempt to RMA it.

You should consider your self Lucky! I had a DNA75 burn up like that & it took out the whole mod with it! You just need a new board

RMA's are getting harder to get from Evolv these Days, Good Luck with that!

 

[tiburonfirst]

 

[BillW50]

 

[dwcraig1]

You should consider your self Lucky! I had a DNA75 burn up like that & it took out the whole mod with it! You just need a new board

RMA's are getting harder to get from Evolv these Days, Good Luck with that!

I'm hoping that they think I'm "special"........but highly doubt it. Most likely they don't even know of my involvement .

 

[dwcraig1]

 

[dwcraig1]

 

[BillW50]

You should consider your self Lucky! I had a DNA75 burn up like that & it took out the whole mod with it! You just need a new board

Did it overheat while charging?

 

[Steamer861]

Did it overheat while charging?

No, it was an 18650 mod,(Charged Externally) those 2 big things IDK what they are? They burned up & melted my mod The burnt plastic smell was so bad that the whole mod was Toast!

 

[BillW50]

No, it was an 18650 mod,(Charged Externally) those 2 big things IDK what they are? They burned up & melted my mod The burnt plastic smell was so bad that the whole mod was Toast!

Oh yes, the two large inductors just like dwcraig1. Maybe dwcraig1's had nothing wrong with his BMIC after all, because yours didn't even have USB power.

 

[mikepetro]

@awsum140

I tried to PM you here but your box is full. Check your PMs elsewhere.....

 

[dwcraig1]

Over yonder, "E", has been down for a few hours. Even the Alpha site is down.
Their commercial site is still operational.

 

[BillW50]

 

[dwcraig1]

 

[tiburonfirst]

 

[dwcraig1]

New board went into my Silo Galaxy this morning.

 

[retird]

Over yonder, "E", has been down for a few hours. Even the Alpha site is down.
Their commercial site is still operational.

E-mailed to Mr. B....

 

[dwcraig1]

E-mailed to Mr. B....

Did you get a reply?