Fusions are back in stock tonite!

[ukeman]

Let's see what these spec out at... 2. to 2.5 should be just fine for my Provari.

I have a couple at 2.3 Ohm from a couple months ago, and they are fantastic anywhere from low 3v to low 4v....

they don't crackle and pop, don't get hot, but they pump up the volume in vapor and hold the taste just right... have one on for two days now, re-dripping every 15-20 vapes or so. Perfect.

Thanks to all you carto vapers who kept on with cartos so that Iken could improve on them.

He was selling a small amount of Dual Coil cartos but they sold out in a flash....

 

[Tat_skull]

Let's see what these spec out at... 2. to 2.5 should be just fine for my Provari.

I have a couple at 2.3 Ohm from a couple months ago, and they are fantastic anywhere from low 3v to low 4v....

they don't crackle and pop, don't get hot, but they pump up the volume in vapor and hold the taste just right... have one on for two days now, re-dripping every 15-20 vapes or so. Perfect.

Thanks to all you carto vapers who kept on with cartos so that Iken could improve on them.

He was selling a small amount of Dual Coil cartos but they sold out in a flash....

I'd be curious to see what these spec out at also. I have a few fusions(well enough for awhile), and everyone I have used thus far read at 2.8 on the provari. These really crank for me at 5.0. This combo is all I use on the go, but at home, it's gotta be atty's!!!

 

[ukeman]

i read somewhere that he had started out with 2.5, then they started coming in lower, or was that higher...?
the site says 2.5.
i've had one on for a couple days and it's up to 3.0 now... from 2.3... i've been creeping up in voltage to 4.2 right now, but i will definitely keep going.

 

[5cardstud]

Building the heating coils in cartomizers isn't an exact science so the Ohms will vary a bit. You also have to take into consideration the different meters used to check these. They are built to the 2.5 Ohm rating and are generally pretty close to that plus or minus a couple.