Hello all,
I just recently bought a Goblin rta v2 and all I can say is I love it so much! I built a pair of dual 26 gauge microcoils with a final reading of 0.45 ohms. After I took it apart last night to rewick it, I noticed that the clear middle O-Ring around the middle 2 coil screw post was a bit melted. It must have happened when I was dry firing my coils when I first built them and it must have got too hot. It just melted a small sliver of it and it hasn't been leaking or anything. I scrubbed off the burnt rubber and rinsed it out. You can barely see the melted spot.
Should I get a replacement for it or even worry about it if it isn't causing any issues at all? Thank you.
I just recently bought a Goblin rta v2 and all I can say is I love it so much! I built a pair of dual 26 gauge microcoils with a final reading of 0.45 ohms. After I took it apart last night to rewick it, I noticed that the clear middle O-Ring around the middle 2 coil screw post was a bit melted. It must have happened when I was dry firing my coils when I first built them and it must have got too hot. It just melted a small sliver of it and it hasn't been leaking or anything. I scrubbed off the burnt rubber and rinsed it out. You can barely see the melted spot.
Should I get a replacement for it or even worry about it if it isn't causing any issues at all? Thank you.
