Good to know from the master...I just got my Spheroid last Friday, but I've been running a micro coil in another atty for about a month, and it still looks great. I think that the regular wick replacements help keep it looking good.
I did have quite a bit of trouble getting the Spheroid up & running. First I had too much "fluff". Then, I had to keep trimming the wick to make sure it was just touching the fluff, and not compressing when I reassembled. I could get almost no draw at all until I sorted those two issues. Even afterwards, the draw is still super tight.
I read much earlier in the thread that the air hole directly under the coil should be 1.2-1.25mm, and the holes in the 510 threading should be 1.0mm. The holes in my Spheroid are much smaller; 1.0mm & 0.8mm respectively. I was able to ream out the holes in the threading to 1 mm, as the material is fairly thin, but I could only ream out the vertical hole to about 1.1mm. My hardened steel micro reamers are no match for that thick of stainless steel.
It is a little better, but only slightly; has anyone else had this issue, and how did you solve it?
Sent from my iPad using Tapatalk
Send an email please to info@vapourart.com, referring your order number and your issue and tomorrow we shall fix it definitely.